User manual PHILIPS HQ 8870

[. . . ] Number of charge percentage indications that burn green decreases too. Running low C Batteriesbatteries are running low, the When the 20% charge percentage indication turns red. When you switch the shaver off, the 20% charge indication blinks red for 4 seconds. [. . . ] Put the protection cap on the shaver every time you have used it, to prevent damage. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Always check if the water is not too hot before you start cleaning the shaver under the tap. Never dry the shaving unit with a towel or tissue as this may damage the shaving heads. When you clean the appliance, it is not necessary to take the shaving heads (cutters and guards) apart. If you want to take them apart, be sure not Accidentally mix up the sets, it could take several weeks before optimal shaving performance is restored. Every day: shaving unit and hair chamber 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. Make sure the inside of the shaving unit and the hair chamber have been cleaned properly. Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the shaving unit and hair chamber without water by using the brush supplied. - Carefully clean the inside of the shaving unit and the hair chamber with the brush. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Lubricate the trimmer teeth with a drop of sewing machine oil every six months. Replace damaged or worn shaving heads with HQ8 Philishave Sensotec shaving heads only. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Remove the shaving heads and place new ones in the shaving unit in such a way that the parts with the small holes point towards the centre of the shaving unit. Make sure that the projections of the shaving heads fit exactly into the recesses. [. . . ] Clean the shaver thoroughly before you continue shaving (see 'Cleaning and maintenance'). Do nota clean more than one cutter and guard at time, Since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. [. . . ]