User manual PHILIPS HC3424/80

[. . . ] -- Children should be supervised to ensure that they do not play with the appliance. Caution -- Never immerse the appliance in water or rinse it under the tap. -- Use, charge and store the appliance at a temperature between 5°C and 35°C. [. . . ] Make sure the surface of the comb always stays in contact with the skin. Trimming without comb Use the trimmer without the trimming comb to clip hair close to the skin (0. Be careful when you trim without comb because the cutting element removes every hair it touches. Using the beard comb (HC5440/80, HC3424/80, HC3420/80, HC3420/17 only) The hair length settings are indicated in millimeters, the comb cuts the hair to a length of 1mm to 23mm. 10 ENGLISH 2 Turn the length setting adjuster to the desired length setting. 4 To trim most effectively, move the trimmer against the hair growth direction. Make sure the surface of the comb always stays in contact with the skin. Cleaning Never use scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or acetone to clean the appliance. Note: Only the cutting element and the comb can be cleaned with water. 1 Make sure the appliance is switched off and disconnected from the mains. 3 Remove the comb and clean it with the brush or rinse it under the tap. ENGLISH 5 Clean the cutting unit with the brush or rinse it under the tap. To reattach the cutting unit, insert the lug of the cutting unit into the guiding slot. 8 Insert the lug of the cutting unit into the guiding slot (1) and push the cutting unit back onto the appliance (2). [. . . ] Do not connect the appliance to the mains again after you have opened it. Guarantee and support If you need information or support, please visit www. 98 SVENSKA Introduktion Gratulerar till inköpet och välkommen till Philips! [. . . ]