User manual PHILIPS FW66

[. . . ] ________________________________ t s This "bolt of lightning" indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering. The "exclamation point" calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. CAUTION: To prevent electric shock, match wide blade of plug to wide slot, and fully insert. MAC5097 pg 01-28/C1-C10/37-En 2 16/11/1999, 1:55 PM 3139 116 19292 (ENG) 3 Visit our World Wide Web Site at http://www. philipsusa. com I ST RATION N S· REG Dear Philips product owner: Thank you for your confidence in Philips. You've selected one of the best-built, best-backed products available today. And we'll do everything in our power to keep you happy with your purchase for many years to come. [. . . ] Note: ­ All the available discs will play once, then stop. TUNING PRESET DB B OP T AL IM JA ZZ DIGITAL SOUND CONTROL SEARCH PROGRAM STOP· CLEAR PLAY· PAUSE PREV CLOCK· TIMER DIM NEXT DSC CK TE HN C O Warning!Do not use any accessories such as disc stabilizer rings or CD treatment sheets, etc. , which may damage the CD mechanism. 3) When the CD changer is loaded with CDs, do not turn over or shake the system. This may jam the changer. You may load three discs in the CD changer for continuous playback without interruption. pg 01-28/C1-C10/37-En RO DIGITAL SOUND CONTROL Disc Change You can change the outer two discs while the third inner disc is stopped or is playing. 2 Replace the discs in the left and right disc trays. 14 16/11/1999, 1:56 PM 3139 116 19292 (ENG) 15 · If you press DISC CHANGE again during playback, the CD will stop playing. TM The CD carousel tray will rotate until the inner tray is rotated out and is ready for changing. 3 Press OPEN·CLOSE to close the CD carousel tray. CD Searching for a particular passage during playback · Press and hold à or á until the desired passage is located. · Play returns to normal when à or á is released. TM The total number of tracks programmed and total playing time appear on the display. Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" appears on the display instead of the total playing time. ­ If the system is reading the discs, programming is not possible, "READING" will be displayed and followed by "DISC X". TM The display will show "SEARCH" until a radio station with sufficient signal strength is found. · Repeat this procedure until the desired station is reached. · To tune to a weak station, briefly press à or á repeatedly until the display shows the desired frequency and/or when the best reception has been obtained. pg 01-28/C1-C10/37-En 16 16/11/1999, 1:56 PM v 1 Press REPEAT on the remote control to select the various repeat modes. TM "TRACK", "DISC", "ALL DISC" or "OFF" will be displayed. · The selected track, selected disc or all available discs will now be played repeatedly until you pressÇ. 2 Press REPEAT until the "OFF" mode is displayed to resume normal playback. TM The REP flag disappears from the display. CD1 · 2 · 3 CD v v FM · AM TUNER v v TAPE 1 · 2 TAPE v VIDEO AUX MASTER VOLUME PRESET ZZ NEXT RO 3139 116 19292 (ENG) 17 Storing Preset Stations You can store up to 40 radio stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display. TM The PROG flag starts flashing and "AUTO" will be displayed. TM The system will search for every available station in the FM waveband first, then search the AM waveband. TM The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. TM The system will remain tuned to the last stored preset radio station. [. . . ] Cleaning Discs · When a disc becomes dirty, clean it with a cleaning cloth. · Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog records. Cleaning the CD lens · After prolonged use, dirt or dust may accumulate at the CD lens. To ensure good playback quality, clean the CD lens with Philips CD Lens Cleaner or any commercially available cleaner. [. . . ]