User manual PHILIPS FR931

[. . . ] owner Confirmation Your completed Warranty Registration Card serves as verification of ownership in the event of product theft or loss. Model Registration Returning your Warranty Registration Card right away guarantees you'll receive all the information and special offers which you qualify for as the owner of your model. Urry H IT HIN 10 Know these AY safety symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Congratulations on your purchase, and welcome to the "family!" Dear Philips product owner: Thank you for your confidence in Philips. [. . . ] Always place the subwoofer vertically, keeping a few centimeters away from the wall. If the subwoofer is placed in the center of a room, the bass could be extremely weakened. If this happens, move the subwoofer away from the center of the room or eliminate the cause of the standing wave by installing a bookshelf on the wall, etc. phase selector · Use PHASE SELECTOR located PHASE at the rear of the subwoofer to SELECTOR select the phase polarity. Before you operate the subwoofer, complete the preparation procedures. Selecting the polarity at either 0° or 180° may determine better bass reproduction effect in certain listening environments (depending on the type of front speakers and the position of the subwoofer). It may also change the expanse and tightness of sound, and affect the feeling of sound field. Select the setting that provides the sound you prefer when listening in your usual listening position. Repeat the adjustment for volume and phase polarity to suit your preference. Once you have adjusted the subwoofer to the settings you desire, use the VOLUME control on the receiver to adjust the volume of the subwoofer and the other speakers. You do not need to adjust the subwoofer settings again even when you change the volume level of the receiver. You can leave any option (values remain unchanged) by pressing 1 PREV. 100 % * VOL BALANCE Adjusts the relative volume balance between the connected speakers. +50 Note: When using the 6 CHANNEL / DVD INPUT the values below cannot be changed. SUBW PRESENT Subwoofer present: yes/no CENTER SPEAKR Center speaker present: yes/no REAR SPEAKER Rear speakers present: yes/no * SPEAKR SIZES Chooses the speaker sizes of the used speakers, for optimal sound reproduction. LARGE indicates a speaker which can reproduce frequencies lower than 50 Hz. If FRONT SIZE is set to SMALL, CENTER SIZE can only be set to SMALL and consequently a subwoofer must be connected. SUBW PRESENT (FR 965, FR 968 only) Subwoofer present: yes/no FRONT SIZE Left and right front speakers: small/large CENTER SIZE Center speaker: small/large REAR SIZE Rear speakers: small/large * SPK DISTANCE Distance between the usual listening position and the speakers. 30 ft) English 18 MENUS * SELECT INPUT Assigns the audio input connectors to the different source selections chosen with SOURCE SELECTOR (see "Source selection" for details). COAX1 Digital coaxial input 1, COAX 1 IN COAX2 Digital coaxial input 2, COAX 2 IN OPT (FR 965, FR 968 only) Digital optical input, OPTICAL IN OPT 1 (FR 975 only) Digital optical input, OPTICAL 1 IN OPT 2 (FR 975 only) Digital optical input, OPTICAL 2 IN SAT IN Analog audio input SAT IN VCR IN Analog audio input VCR IN TV IN Analog audio input TV IN CDR IN Analog audio input CDR IN CD IN Analog audio input CD IN 6 CH IN Analog audio input 6 CHANNEL / DVD INPUT * TUNER Setup for preset radio stations (see "TUNER" for details). AUTO INSTALL Stores radio stations automatically MAN INSTALL Stores radio stations manually GIVE NAME Allows you to assign names to stored radio stations RESHUFFLE Resorts stored radio stations If the receiver is connected to a Philips CINEMA LINK TV via the CINEMA LINK system control bus jacks (see "CONNECTIONS"), you may use the TV to set up the system. If CINEMA LINK is on, adjustments on the receiver will be shown on the TV screen for a few seconds. [. . . ] But, because some states do not allow limitations on how long an implied warranty may last, this limitation may not apply to you. Your warranty does not cover: · Labor charges for installation or setup of the product, adjustment of customer controls on the product, and installation or repair of antenna systems outside of the product. Product repair and/or part replacement because of misuse, accident, unauthorized repair or other cause not within the control of Philips Consumer Electronics Company. Reception problems caused by signal conditions or cable or antenna systems outside the unit. [. . . ]