User manual PHILIPS FC9130

[. . . ] Button coupling (specific types only) 1 Connect the tube to the handgrip by pressing the spring-loaded lock button on the handgrip and inserting the handgrip into the tube. Fit the spring-loaded lock button into the opening in the tube ('click') (fig. 2 To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the handgrip out of the tube. 3 Use the same method to connect and disconnect the other accessories. [. . . ] Using the appliance Adjusting suction power 1 You can adjust the suction power, while vacuum cleaning, with the slide control on top of the appliance (fig. 2 Use maximum suction power for vacuum cleaning very dirty carpets and hard floors. With the infrared remote control you can set the suction power to one of 5 different suction power settings. When you switch the appliance on, it will always start running at the highest suction power setting. 2 By pushing the - button, you will reduce the suction power by one setting (fig. 3 By pushing the + button, you will increase the suction power by one setting (fig. 4 Push the standby button to temporarily switch the vacuum cleaner off, for instance when you have to move some furniture (fig. Parking the tube 1 By inserting the ridge on the nozzle into the parking slot, you can park the tube in a convenient position (fig. Storage 1 You can put the appliance in upright position and attach the nozzle to the appliance by inserting the ridge on the nozzle into the slot (fig. 2 Always put the Tri-Active nozzle in carpet setting when you store it and prevent the side brushes from becoming bent. Replacement The dustbag 1 Replace the dustbag as soon as the dustbag-full indicator changes colour (fig. The dustbag is full when the colour of the indicator has changed when the nozzle is not placed on the floor. Place your fingers at the front of the cover and press with your thumb on the ridge on top of the cover. Make sure you hold the dustbag upright when lifting it out of the appliance. 6 Slide the cardboard of the new dustbag into the two grooves of the dustbag holder as far as possible. The mains cord If the mains cord of the appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips, as special tools and/or parts are required. Cleaning and maintenance of filters Motor Protection Filter Every time you empty or replace the dustbag, clean the Permanent Motor Protection Filter. 2 Take the Motor Protection Filter holder out of the appliance and clean the filter by shaking it over a dustbin (fig. [. . . ] Com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Troubleshooting guide The suction power is insufficient: 1 Check if the suction power control is in the required position (see 'Using the appliance'). Switch the vacuum cleaner on to make the airflow suck the obstructing material out of the blocked-up item (fig. [. . . ]