User manual PHILIPS CDR760

[. . . ] Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. Follow Instructions - All operating and use instructions should be followed. Water and Moisture - The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like. [. . . ] Note: CD-R discs recorded with a computer can only be used when they are correctly treated according the audio standard (IEC958: Consumer part). Do not expose the CD recorder, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). If the CD recorder cannot read CDs correctly, use a cleaning CD to clean the lens before taking the CD player to be repaired. The lenses may cloud over when the CD recorder is suddenly moved from cold to warm surroundings, making it temporarily impossible to play a CD. Leave the CD recorder in a warm environment until the moisture evaporates. Messages as listed and explained here may appear on the display for your guidance. Lights up when digital input is selected and flashes when digital input is incorrect. Lights up during erase recording and flashes in erase standby 0 COPY PROHIBIT . Flashes during unfinalize disc standby, lights during unfinalize disc INPUT . The CD recorder has the following recording inputs: - Digital optical input - Digital coaxial input - Analogue input The CD recorder has the following playback outputs: - Digital coaxial output - Analogue output The connections to be made depend upon the possibilities your audio equipment offers. If your equipment does not offer digital connections, the high quality Analogue-Digital-Converter of your CD recorder will ensure high audio performance when recordings are made from the analogue input. playback via the digital coaxial output of the CD recorder gives the best audio performance. If your equipment does not offer digital connections the high quality Digital-AnalogueConverter of the CD recorder ensures a high sound quality via the analogue output. We recommend that both digital and analogue connections be made, so that analogue recordings can be made when digital recording is not possible. The most common ways of connecting the CD recorder are explained below. If you still have difficulties with the connections, feel free to contact the Philips Consumer Service desk in your country. ⷠThe Serial Copy Management System (SCMS) only allows digital recording under specific conditions: - It is not possible to make a digital copy from a digital copy. Digital recordings can be made from CDs (or other sources with an output Sample Frequency of 44. Important: If you want to play the recorded CD-R disc on a regular CD player, it must be finalized first. Preparing for digital recording 1 Make sure the disc is absolutely free of scratches and dust particles. 3 Press AUTO/MANUAL to switch between auto and manual track numbering. AUTO: The track increments are automatically copied from the digital source material. [. . . ] Tracks can be programmed more than once, but each time counts as a track. Press the required track number using the numerical keys on the remote control. Searching during CD play 1 Hold down or § (or 5 or 6 on the remote control). The player first searches backwards or forwards at 10 times normal speed with sound at low volume, then goes to fast reverse or fast forward with sound muted. [. . . ]