User manual PHILIPS AZ2060/00C

[. . . ] Using AC Mains 1 Check if the mains supply, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. 2 If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains. 4 To disconnect the mains supply, unplug the set from the wall socket. [. . . ] Reviewing the programme In the stop position, press and hold PROGRAM until the display shows all your stored track numbers in sequence. Erasing a programme You can erase the contents of the memory by: ¥ opening the CD door; ¥ selecting TUNER, AUX or TAPE sound sources; ¥ pressing 9 twice during playback or once in the stop position. AUX (audio cable not included) Playing a CD This CD player plays Audio Discs including CD-Recordables and CD-Rewritables. To improve radio reception: 1 Press y to on, then Source Selector to select CD. ¥ For FM, extend, incline and turn the telescopic aer2 Insert a CD with the printed side facing up and ial. Direct TM is displayed as the CD player scans the this aerial by turning the whole set. contents of a disc, and then the total number of tracks and playing time are shown. You can store up to a total of 30 radio stations in the 4 To pause playback press 2;. Press 2; again to memory (20FM, 5MW and 5LW), manually or automatresume play. Helpful hints: CD play will also stop when: Manual programming ­ the CD door is opened 1 Tune to your desired station (see Tuning to radio ­ the CD has reached the end stations). 3 Press PRESET -, + (on the remote control 3, 4) once or more to allocate a number from 1 to 20 for FM, 1 to 5 to MW and 1 to 5 for LW. Helpful hints: You can erase a preset station by storing another frequency in its place. This 3. 5mm socket allows you to connect other audio equipment to your system e. g. 2 Use an audio cable to connect the AUX socket to the LINE OUT/headphone socket on your external 1 To select play mode, press MODE (SHUFFLE or equipment. 3 To avoid noise distortion, turn down the volume on 2 Press 2; to start playback if in the stop position. 3 To select normal playback, press MODE repeatedly 4 To adjust the sound and volume, use the sound until the various modes are no longer displayed. controls on your external equipment and the -- can also press 9 to cancel your play mode. Programming track numbers In the stop position, select and store your CD tracks in the desired sequence. 1 Press or § (on the remote control ¡ or TM) to select your desired track number. [. . . ] As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: ¥ The BLUE wire must be connected to the terminal which is marked with the letter "N" or coloured BLACK. ¥ The BROWN wire must be connected to the terminal which is marked with the letter "L" or coloured RED. ¥ Do not connect either wires to the earth terminal in the plug which is marked by the letter "E" or by the safety earth symbol or coloured green or green-and-yellow. [. . . ]