User manual PHILIPS AJ3650

[. . . ] 7 Sensor support ­ pulls out to stand the sensor POWER SUPPLY Mains adapter 1 Connect the mains adapter to the set's DC IN socket and to the power socket. 2 Always disconnect the mains adapter if you are not using the set. Helpful hints: To avoid damage to the set, use only the adapter supplied!Pull out the plastic protective sheet to activate the clock backup battery (CR2032). [. . . ] ­ It is not possible to adjust the alarm time during an alarm call or alarm repeating mode. SWITCHING OFF THE ALARM REPEAT ALARM This repeats your alarm call at 9 minute intervals. · During the alarm call, press REPEAT ALARM /BRIGHTNESS CONTROL. · Repeat if desired. DEACTIVATING THE ALARM COMPLETELY · Press ALARM 1 or ALARM 2 button once or more until the SLEEP disappears. About Sleep This set has a built-in sleep timer, which enables the radio to be automatically switched off or relaxation music volume to be turned down gradually after a set period of time. Press SLEEP repeatedly to switch between:15->30->60->90->120->OFF. Press PRESET +/- repeatedly to select next or previous in-built relaxation music. USING THE PROJECTION With this projection feature, you can conveniently project the clock time onto a surface e. g. Press and hold PROJECTION/IMAGE FLIP to flip the projected image vertically, along the horizontal axis. To change the projection slightly to a different angle, turn the IMAGE ROTATE wheel (maximum 90 degree left or right). Press PROJECTION/IMAGE FLIP to switch between: bright, dim, very dim and off. Helpful hints: ­ Turn the projection lens right upside before trying to push it back into the set. Please do not look at the projection lens directly. USING THE SENSOR TO DETECT OUTDOOR TEMPERATURE (See 3) The main unit comes with an outdoor sensor. Using the sensor, the unit is capable to measure and display outdoor temperature through receiving data trasmitted from the sensor placed at other location. · For the first time using the outdoor sensor and the main unit, press RESET located on the sensor back, and RESET located in the bottom of the main unit. [. . . ] Please observe local regulations on the disposal of packing materials and old equipment. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. [. . . ]