User manual PHILIPS AJ3226

[. . . ] % ^ # English Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. philips. com/welcome. CONTROLS (see fig. [. . . ] To adjust the clock and alarm times accurately, always make sure you press UP / DOWN separately and not simultaneously. 1 Turn the clock control to SET TIME or SET AL 1 or SET AL 2 to set the clock or alarm time respectively. 2 Press UP / DOWN repeatedly or hold down on the respective button to adjust the hours and minutes. 4 After you have set both the hour and minutes, turn the clock control to CLOCK to run on clock time. SELECTING THE ALARM MODE GENERAL If you wish to use the alarm, you must first set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. · Select your choice of alarm mode by adjusting AL 1 or AL 2 to RADIO or BUZ. BUZ on AL 1 is a low tone buzzer while BUZ on AL 2 is a high tone. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · Press ALARM RESET during the alarm call. CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: · Adjust AL 1 or AL 2 to OFF position. SLEEP About Sleep This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. 3 To set the sleep function, do one of the following: · Press and hold SLEEP. · Hold down SLEEP, and press UP/DOWN repeatedly to adjust sleep time from 59 minutes downward. [. . . ] · Battery shall not be exposed to excessive heat such as sunshine, fire or the like. CAUTION Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation. [. . . ]