User manual PHILIPS 55690-17-16

[. . . ] The ringer is off. If you are using a voice mailbox from yourprovider, thisiconflasheswhen there is a new message. It remains steadily on when the voice messages are already viewed in the call log. * This is network dependent It displays when you scroll up/down a list or increase and decrease the volume. [. . . ] * This is network dependent It displays when you scroll up/down a list or increase and decrease the volume. Press REDIAL/C to read. 1 Connect Telephone socket Power socket Power socket Power adapter Connect the base station 1 Connect each end of the power adapter to: Telephone base station 2 1 3 · the DC input jack at the bottom of the base station; · the power socket on the wall. 2 Connect each end of the line cord to: · the telephone socket at the bottom of the base station; · the telephone socket on the wall. For multi-handset version only: 3 Connect each end of the power adapter to: · the DC input jack at the bottom of the extra handset charger. · the power socket on the wall. Extra handset charger 2 Get started 1 The batteries are pre-installed in the handset. Pull the battery tape off 2 Whenusingyourphoneforthefirsttime, youseeawelcome Configure your phone from the battery door before charging. · If the time is in 12-hour format, press / key to select [AM] or [PM]. Charge your phone Place the handset on the base station to charge the handset. » Registration is completed in less than 2 minutes. To delete a call record 2 Press MENU/OK. 4 Press MENU/OKtoconfirm. Restore default settings You can reset your phone settings to the original factory settings. 3 Press MENU/OKtoconfirm. Technical data · CORUN: 2 x AAA NiMH 1. 2V Rechargeable 500mAh batteries · SANIK: 2 x AAA NiMH 1. 2V Rechargeable 500mAh batteries Battery » Thehandsetdisplaysaconfirmationrequest. Power adapter » All settings are reset » The welcome screen displays. Base and charger: · Philips: SSW-1920EU-2/SSW-1920UK-2/S003PV0600050/ S003PB0600050: Input: 100-240V 50/60Hz 0. 2A; Output: 6V 500mA Frequently asked questions I cannot change the settings of my voice mail, what do I do? · The handset is out of range. · If the handset displays [UNREgIStERED], register your handset (See the section on Register the handsets). No signal bar displays on the screen. The voice mail service is managed by your service provider but not the phone itself. Contact your service provider to change the settings. If I fail to register the additional handsets to the base station, what do I do?Move it closer to the base station. · Ensure the batteries are inserted correctly. Disconnectthepowersupplyfirstand clean the contacts with a damp cloth. [. . . ] Move it closer to the base station. · Ensure the batteries are inserted correctly. Disconnectthepowersupplyfirstand clean the contacts with a damp cloth. · Ensure there are power and phone connections. The handset on the charger does not charge. · The handset is nearly out of range. [. . . ]