User manual PANASONIC RP-WF950

[. . . ] Dispose of used batteries according to the manufacturer's instructions. This product would need reset manually under a strong electrostatic discharge. The radio frequencies this unit uses (863-865 MHz) are not permitted in some countries. [. . . ] The unit is in the standby condition when the AC adaptor is connected. the primary circuit is always "live" as long as the AC adaptor is connected to an electrical outlet. Note The OPR/CHG indicator lights in green when the transmitter receives input. It does not light just by connecting the transmitter to an AC power source. Note Under optimum conditions, the headphones can pick up clean signals from the transmitter to a maximum of 100 meters. Metal between the two units and the presence of other radio waves can cause interference to occur at a shorter distance. This interference can be cleared by moving closer to the transmitter, removing the obstructions, or changing the transmitter channel ( see page 14). You may occasionally experience interference due to dead spots in the area covered by the transmitter. This phenomena occurs with any kind of radio signal and is not a malfunction. Turn the volume on the sound source up as much as possible without causing distortion. Sound is more susceptible to noise interference when the source volume is set to low. If there is interference, you can change the transmitter channel to improve reception ( see page 14). To use the SURROUND sound feature, set the [SURROUND] switch to "ON". Note Avoid listening for prolonged periods of time to prevent hearing damage. Discontinue use if you experience discomfort with the headphones that directly contact your skin. When audio signals are input, the transmitter's power is turned on (The OPR/CHG indicator lights in green. When audio signals are not input for 1-2 minutes, its power is automatically turned off. (The OPR/CHG indicator goes out) When the volume of the connected unit is too low, this function doesn't work. [. . . ] Customers can download a copy of the original DoC to our R&TTE products from our DoC server: http://www. De Contact to Authorised Representative: Panasonic Marketing Europe GmbH, Panasonic Testing Centre, Winsbergring 15, 22525 Hamburg, Germany This product is intended to be used in the following countries. When extremely dirty, wipe away the dirt using a cloth dampened with water and firmly wrung out, and then wipe away any remaining moisture with a dry cloth. [. . . ]