User manual PANASONIC KXTS520EX

[. . . ] (It is normal for the adaptor to feel warm during use. ) Battery installation/Battery charge Important: L Use the supplied rechargeable batteries. For replacement, we recommend using the Panasonic rechargeable batteries noted on page 2. L When the batteries are fully charged, the charge indicator goes off. Charge indicator Rechargeable Ni-MH ONLY Confirm "Charging" is displayed. Note: L If the batteries are fully charged, but the operating time seems to be shorter, clean the battery ends (S, T) and the charge contacts with a dry cloth and charge again. 3 Registering a handset to the base unit 1 Base unit: NKX-TGP500 series Press and hold {ALL} for about 4 seconds until the STATUS indicator flashes in red. NKX-TGP550 series Press and hold {ALL} for about 4 seconds until the registration tone sounds and the STATUS indicator flashes in red. [. . . ] L The next step must be completed within 90 seconds. 2 Handset: Press {OKL}, then wait until a long beep sounds. Note: L If an error tone sounds, or if _ is still displayed, register the handset according to the registering section of the base unit's User Guide on the Panasonic Web site. See page 1 for Panasonic URL. Display language 1 {MENU} (center of joystick) i {#}{1}{1}{0} 2 {V}/{^}: Select the desired setting. i {OFF} 4 Belt clip N To attach N To remove Wall mounting 1 Drive the screws (not supplied) into the wall. 2 Mount the charger (A), then slide it down (B) and to the right (C) until it is secure. 25. 4 mm (1 inch) A B C Screws 5 For your safety To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product. WARNING Power connection L Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. L Unplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. Confirm that smoke has stopped emitting and contact your phone system dealer. Installation L To prevent the risk of fire or electrical shock, do not expose the product to rain or any type of moisture. Privacy of communications may not be ensured when using this phone. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ­ Consult the dealer or an experienced radio/TV technician for help. FCC RF Exposure Warning: L This product complies with FCC radiation exposure limits set forth for an uncontrolled environment. L This handset may not be collocated or operated in conjunction with any other antenna or transmitter. L For body-worn operation, the handset must be used only with a non-metallic accessory. [. . . ] L For body-worn operation, the handset must be used only with a non-metallic accessory. Use of other accessories may not ensure compliance with FCC RF exposure requirements. Notice: L FCC ID can be found inside the battery compartment or on the bottom of the unit. 8 Compliance with TIA-1083 standard: Telephone handsets identified with this logo have reduced noise and interference when used with T-Coil equipped hearing aids and cochlear implants. Compatible with Hearing Aid T-Coil T TIA-1083 Notice LThis product is designed for use in the United States of America. Sale or use of this product in other countries may violate local laws. [. . . ]