User manual PANASONIC KX-TG6841

[. . . ] Please read these operating instructions before using the unit and save them for future reference. consulte “Guía Rápida Española” , página 60. KX-TGA680 KX-TGA680 KX-TGA680 KX-TGA680 KX-TGA680 KX-TGA680 KX-TGA680 Quantity 1 2 3 4 5 2 3 Single handset models: Intercom calls can be made between handsets by purchasing and registering one or more optional handsets (page 5). By attaching the key detector to an easy-to-lose item in advance, you can locate and find the mislaid item. [. . . ] 1 Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to the base unit. A MSELECTN MbN: “Yes” a MSELECTN MOFFN 2 3 4 Registering a handset to the base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit, re-register the handset. 1 2 Handset: MMENUN#130 Base unit: Press and hold MLOCATORN for about 5 seconds until the registration tone sounds. R If all registered handsets start ringing, press MLOCATORN again to stop, then repeat this step. note: R While registering , “Base in registering” is displayed on all registered handsets. R When you purchase an additional handset, refer to the additional handset’s installation manual for registration. 3 Deregistering a handset A handset can cancel its own registration to the base unit, or other handsets registered to For assistance, please visit http://www. Phonebook name display When caller information is received and it matches a phone number stored in the phonebook, the stored name in the phonebook is displayed and logged in the caller list. Talking Caller ID Caller ID features Handset / Base unit When an outside call is being received, the caller information is displayed. Caller information for the last 50 callers is logged in the caller list from the most recent call to the oldest. R If the unit cannot receive caller information, the following is displayed: – “Out of area”: The caller dials from an area which does not provide a Caller ID service. R If the unit is connected to a PBX system, caller information may not be properly received. *1 Handset *2 Base unit Handset / Base unit This feature lets you know who is calling without looking at the display. To use this feature, you must: – subscribe to a Caller ID service of your service provider/telephone company. When caller information is received, the handsets and base unit announce the caller’s name or phone number received from your service provider/telephone company following every ring. R Caller ID service has a limit of how many characters can be displayed. If the caller’s name is too long, the unit may not be able to display or announce the entire name. R The announcement is heard at the same level as the ringer volume (page 17, 28, 30). R If you turn on the answering system and set the number of rings “2 rings” (page 45), the unit does not announce the caller information. If “Toll saver” is selected and there is a new message, the unit does not announce the caller information. R When you receive a call while on the phone, the 2nd caller’s name is not announced even if you subscribe to both Caller ID and Call Waiting with Caller ID services. [. . . ] You must mail-in your product prepaid during the Limited Warranty period. This Limited Warranty excludes both parts and labor for batteries, antennas, and cosmetic parts (cabinet). This Limited Warranty only applies to products purchased and serviced in the United States or Puerto Rico. This Limited Warranty is extended only to the original purchaser and only covers products purchased as new. [. . . ]