User manual PANASONIC KXTG1611FR

[. . . ] 36 2 TG8521E(e). book Page 3 Wednesday, March 17, 2010 3:39 PM Introduction Model composition Series KX-TG8521 series Model No. KX-TGA850 KX-TGA850 KX-TGA850 KX-TGA850 Quantity 1 2 3 4 *1 Feature differences: Intercom calls can be made between handsets by purchasing and registering one or more optional handsets (page 4). L The suffix (E) in the following model numbers will be omitted in these instructions: KX-TG8521E/KX-TG8522E/KX-TG8523E/KX-TG8524E Accessory information Supplied accessories No. 1 2 3 Accessory item/ Part number AC adaptor/ PQLV219EW or PQLV219EZ Telephone line cord/ PNJA1037Z (for U. K. ) Rechargeable batteries*1/ HHR-55AAAB or N4DHYYY00005 Handset cover*2 Belt clip/PNKE1054Z1 Charger*3 Quantity KXTG8521 1 1 2 KXTG8522 2 1 4 KXTG8523 3 1 6 KXTG8524 4 1 8 4 5 6 1 1 -- 2 2 1 3 3 2 4 4 3 *1 See page 4 for replacement battery information. [. . . ] If you select "On" without entering any handset name, "Handset 1" to "Handset 6" is displayed. Note: L To correct a digit, press {<} or {>} to move the cursor to the digit, then make the correction. Changing the start and end time 1 2 1 (centre of navigator key) i {#}{2}{3}{7} Continue from step 3, "Turning night mode on/off", page 28. 1 2 3 4 5 Setting the ring delay This setting allows the handset to ring during night mode if the caller waits long enough. If you select "No Ringing", the handset never rings during night mode. 1 (centre of navigator key) i {#}{1}{0}{4} Enter the desired name (max. i M 2 times {ic} 1 2 1 (centre of navigator key) i {#}{2}{3}{9} {V}/{^}: Select the desired setting. i M i {ic} Note: L When the answering system answers the call, this feature does not work. Selecting categories to bypass night mode Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. 1 2 1 (centre of navigator key) i {#}{2}{4}{1} {V}/{^}: Select your desired categories. i t L "Q" is displayed next to the selected category numbers. Helpline Tel. 01289 8333 29 TG8521E(e). book Page 30 Wednesday, March 17, 2010 3:39 PM Programming Important: L When the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list (page 34) with 7 after the call is disconnected. Storing unwanted callers You can store up to 30 phone numbers in the call barred list by using the caller list or by entering the numbers directly. A base unit and the handsets it communicates with is called a "radio cell". 3 4 Note: L While registering, "Base in registering" is displayed on all registered handsets. Helpline Tel. 01289 8333 31 TG8521E(e). book Page 32 Wednesday, March 17, 2010 3:39 PM Programming L When you purchase an additional handset, refer to the additional handset's installation manual for registration. Selecting a base unit When "Auto" is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made. 1 2 3 1 (centre of navigator key) i {#}{1}{3}{9} {V}/{^}: Select the base unit you want to cancel. i M {V}/{^}: "Yes" i M i {ic} Note: L To register a handset to another base unit or to the same base unit again, see page 31. 1 2 1 (centre of navigator key) i {#}{1}{3}{7} {V}/{^}: Select the desired base unit number, or "Auto". i M L The handset starts searching for the base unit. Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. Setting the repeater mode Deregistering a handset A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system. 1 1 (centre of navigator key) i {#}{1}{3}{1} L All handsets registered to the base unit are displayed. {ic} 1 2 1 (centre of navigator key) i {#}{1}{3}{8} {V}/{^}: Select the desired setting. [. . . ] Contact your service provider/telephone company. "FD" is displayed. "FE" is displayed. "E0" is displayed. Answering system Problem The unit does not record new messages. L If your own greeting message is not recorded properly, callers are unable to leave a message. L If you subscribe to a voice mail service, messages are recorded by your service provider/telephone company, not your telephone. [. . . ]