User manual PANASONIC HRS100400E

[. . . ] €¢ Four ThirdsTM and Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. The LEICA DG lenses are manufactured using measurement instruments and quality assurance systems that have been certified by Leica Camera AG based on the company’s quality standards. €¢ Other names of systems and products mentioned in these instructions are usually the registered trademarks or trademarks of the manufacturers who developed the system or product concerned. Book 3 ページ ２０１６年１月１９日　火曜日　午前９時３５分 ENGLISH -If you see this symbolDisposal of Old Equipment Only for European Union and countries with recycling systems This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste. [. . . ] €¢ When either the [AF/MF] switch of the lens or the setting of the camera is set to [MF], Manual Focus (MF) is enabled. 1 2 3 4 1 2 3 4 5 Lens surface Built-in slide lens hood (P6) Focus ring Zoom lock ring 6 7 8 9 10 Rotate to focus when taking pictures with manual focus (MF). When carrying the lens, rotate this ring to lock the zoom ring to prevent the lens from extending under its own weight. 10 Focusing distance range selector switch [FULL]: It can focus between the ranges of 1. 11 Lens fitting mark 12 Lens mount rubber 13 Contact points 5 SQT1200 SQT1200_E. Book 6 ページ ２０１６年１月１９日　火曜日　午前９時３５分 Note • If you zoom after focusing, focusing errors may occur. €¢ In very quiet situations Auto Focus operating sounds may be recorded during motion picture recording. in such situations , switching to Manual Focus will improve the situation. To [ON] when recording a motion picture, operating sounds may be recorded. €¢ After detaching the lens from the digital camera, be sure to attach the lens cap/lens rear cap. ˆ« Attaching Filters • Vignetting may occur if using 2 or more filters at the same time. €¢ It is possible to attach the lens cap or the supplied lens hood with the filter already attached. €¢ You cannot attach a conversion lens or adaptor to this lens. A filter may be used, but attaching any other element may cause damage to the lens. Using the Lens Hoods The lens comes with a built-in slide lens hood and supplied lens hood. €¢ The built-in slide lens hood and supplied lens hood can be used together at the same time. €¢ To use the built-in slide lens hood, slide it in the direction of the arrow. We recommend locking the zoom ring with the zoom lock ring before performing operations. Attaching/Detaching the Lens For information on how to attach and remove the lens, refer to the operating instructions for your digital camera. €¢ Before attaching or detaching the lens, check that the digital camera is turned off. [. . . ] €¢ If such substances get onto the lens they can damage the exterior case or cause the paint to peel. €¢ This could cause the lens to collect an excessive amount of light, resulting in fire and malfunction. €¢ Under no circumstances should the unit be stored in any of the following locations since doing so may cause problems in operation or malfunctioning. €“ In direct sunlight or on a beach in summer – In locations with high temperatures and humidity levels or where the changes in temperature and humidity are acute – In locations with high concentrations of sand, dust or dirt – Where there is fire – Near heaters, air conditioners or humidifiers – Where water may make the unit wet – Where there is vibration – Inside a vehicle • Refer also to the operating instructions of the digital camera. [. . . ]