User manual PANASONIC ES-ST25

[. . . ] Before operating this unit, please read these instructions completely and save them for future use. RO H SK CZ PL FIN S N P DK E NL I F D GB Warning • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. € This WET/DRY shaver can be used for wet shaving using shaving lather or for dry shaving. [. . . ] PL 2 FIN  S  3 N P DK E NL I F D GB While charging After charging is completed Abnormal charging Using the shaver switch 1 Press the power mode. [A7] to select the desired shaving ••Each time you press the power switch, the shaving mode changes from “Shaving sensor mode” “Normal mode” “OFF. € Shaving sensor Normal mode mode Beard thickness is automatically The power level is sensed and the constantly power is maintained while automatically shaving. €•After charging is completed, turning the power switch ON with the shaver plugged in will cause charge status lamp to light up and then turn off after 5 seconds. ••Recommended ambient temperature for charging is 10 – 35 °C. It may take longer to charge or the battery may fail to charge properly in extremely high or low temperatures. The charge status lamp ( ) will blink twice every second when there is a problem with charging. €•When charging the shaver for the first time or when it has not been in use for more than 6 months, the charge status lamp ( ) may not glow. €•Charging the battery for more than 1 hour will not affect battery performance. As illustrated and Reading lamps when using When the battery capacity is low The charge status lamp ( ) blinks once every second when operating the shaver. Place at a right angle to your skin and move downwards to trim your sideburns. ►Notes ► ••Before shaving , check that the cleaning shutter is closed. Keeping your finger placed on the power switch during use may switch the mode or turn the shaver OFF. €•Do not use shaving creams or face cleansers containing scrubbing compounds as these may cause the outer foil to clog. 13 TR RO H SK CZ PL FIN S N P ••Start shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. €•You can shave 2 to 3 times after the charge status lamp ( ) blinks. €•If the shaver is operated in the shaving sensor mode in a battery‑shortage condition, the shaving sensor lamp ( ) glows blue, and the charge status lamp ( ) blinks red. DK E NL D ••The shaving sensor may not respond depending on the thickness of the beard or the type of the shaving gel, but this is normal. €•Do not move the short brush in direction (B) as it will damage the inner blades and affect their sharpness. (A) NL I D GB Replacing the system outer foil and the inner blades system outer foil inner blades once every year once every two years ►Removing the outer foil section ► Press the foil frame release buttons [A3] and lift the outer foil section [A] upwards. [. . . ] 19 TR RO H SK CZ PL FIN S N P DK E Battery life NL I F D For environmental protection and recycling of materials GB Disposal of the built-in rechargeable battery Remove the built-in rechargeable battery before disposing of the shaver. Please make sure that the battery is disposed of at an officially designated location if there is one. This figure must only be used when disposing of the shaver, and must not be used to repair it. If you dismantle the shaver yourself, it will no longer be waterproof, which may cause it to malfunction. [. . . ]