User manual PANASONIC ES-LF51-S803

[. . . ] € Do not store the shaver where it will be exposed to direct sunlight or other heat sources. € Hold the AC adaptor when disconnecting it from the household outlet. Intended use • This WET/DRY shaver can be used for wet shaving using shaving lather or for dry shaving. You can use this watertight shaver in the shower and clean with water. [. . . ] The indicators on the LCD panel blink when there is a problem with charging. € When charging the shaver for the first time or when it has not been in use for more than 6 months, the indicators on the LCD panel may not glow. Tips for best shaving results Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Indb 6 2011/02/16 14:49:35 Caution • If you press the power switch for more than 2 seconds, the sonic vibration cleaning mode is activated. € Do not place your fingers on the power switch while using the shaver. This may cause the shaver to turn off or enter the sonic vibration cleaning mode. The used time and the remaining battery capacity are shown alternately after turning off the shaver. When the battery capacity is low • You can shave 1 to 2 times after “10%” appears. Place at a right angle to your skin and move downwards to trim your sideburns. Indb 7 2011/02/16 14:49:35 TR RO H SK CZ PL FIN S N P DK E NL I F D During use After use GB Reading the LCD panel when using Clean Cleaning the shaver We recommend that you clean your shaver with the sonic vibration cleaning mode when the faucet symbol appears on the LCD panel. Press the power switch [D8] for more than 2 seconds to activate the sonic vibration cleaning mode. 5 • After about 20 seconds, it will be automatically turned off, or you can turn it off by pressing the power switch. Remove the outer foil section [B] and press the power switch [D8] for more than 2 seconds to activate the sonic vibration cleaning mode and clean it with running water. Cleaning with the brush Clean the inner blades [C] using the short brush by moving it in direction (A). Clean the system outer foil [B2], the shaver body and the trimmer [D] using the long (A) brush. € Do not move the short brush in direction (B) as it will damage the inner blades and affect their sharpness. Indb 8 2011/02/16 14:49:36 Maintenance Lubrication To maintain shaving comfort for a long time, it is recommended that the oil provided with the shaver is used. Switch off the shaver, and wipe off any excess oil from the outer foils with a soft cloth. Press the foil frame release buttons [D4] and lift the outer foil section [B] upwards. Press the system outer foil release buttons [B3] and pull down the system outer foil [B2]. [. . . ] For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Replacement parts Replacement parts are available at your dealer or Service Center. [. . . ]