User manual PANASONIC CS-CE9PKE

[. . . ] Cleaning and user maintenance shall not be made by children without supervision. Please consult authorised dealer or specialist to clean the internal parts, repair, install, remove and reinstall the unit. improper installation and handling will cause leakage , electric shock or fire. Confirm with authorised dealer or specialist on usage of any specified refrigerant type. [. . . ] € New batteries of the same type must be inserted following the polarity stated. CAUTION Indoor unit and outdoor unit Do not wash the indoor unit with water, benzine, thinner or scouring powder to avoid damage or corrosion at the unit. Power supply Do not disconnect the plug by pulling the cord to prevent electric shock. 5 How to use MODE To select operation mode HEAT - To enjoy warm air • Unit takes a while to warm up. COOL - To enjoy cool air • To reduce power consumption during COOL mode, use curtains to screen off sunlight and outdoor heat. DRY - To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. FAN - To circulate air in the room AUTO - For your convenience • During operation mode selection the POWER indicator blinks. € Unit selects operation mode every 10 minutes according to setting temperature and room temperature. Remote control receiver and indicator POWER/DEICE (Green/Blue) TIMER (Orange) Remote control display AUTO HEAT COOL DRY FAN FAN SPEED AIR SWING OFF/ON MODE TEMP AIR SWING FAN SPEED TIMER ON 1 2 SET 3 Press and hold for approximately 10 seconds to show temperature setting in °C or °F. Raise the front panel: • To use in AUTO mode, press the button once. € To use in COOL mode, press and hold the button until 1 beep is heard, then release. € To use in HEAT mode, press and hold the button until 1 beep is heard, then release. 6 AIR SWING To adjust vertical airflow direction To set the timer 2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset times. 1 TIMER ON 1 2 (Remote control display) 3 OFF CANCEL AC C FAN SPEED To select fan speed (Remote control display) 1 Select ON or OFF timer • Each time pressed: Cancel Example: OFF at 22:00 OFF 2 Set the time • For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. € In HEAT mode, if manual fan speed caused discomfort, set the fan speed to AUTO or lower the fan speed. 2 3 Confirm SET TIMER • To cancel ON or OFF timer , press or OFF to select respective or then press CANCEL. € If timer is cancelled manually or due to power failure, you can restore the timer again by ON pressing or OFF to select respective or SET then press . • The nearest timer setting will be displayed and will activate in sequence. € When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time. € Timer operation is based on the clock set in the remote control and repeats daily once set. ON Operation conditions Use this air conditioner under the following temperature range. € In HEAT mode, if AUTO is set, the horizontal louver is fixed at the predetermined position. [. . . ] For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. [. . . ]