User manual OREGON I300

[. . . ] 7 Screen Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Weather Forecast . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 To Manually Set Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] LED status indicator: Blink during registration with main unit or during sensor search; indicate a successful USB connection Back View: 1. SEARCH: Initiate search for remote sensors; initiate registration with main unit RESET: Reset USB Communications Hub to default settings USB port: Upload / download records to / from PC 7. 9. OUTDOOR THERMO SENSOR FRONT VIEW BACK VIEW USB COMMUNICATIONS HUB FRONT VIEW 1 1 2 BACK VIEW 1 3 1 SEARCH 2 3 4 Front View: 1. LED status indicator: Blink when transmitting a reading Back View: 1. RESET: Reset unit to default settings Channel Switch Battery compartment GETTING STARTED SET UP REMOTE SENSOR 1. Insert the batteries, matching the polarities (+ / -) and press RESET. Close the battery door. 6. Press and hold SEARCH on USB Communications Hub to initiate search and start receiving data from the sensor. NOTE USB Communications Hub will search only for already registered sensor or new sensor reset within last 30 minutes. For best results: · Place the sensor within 100 m (300 ft) of the USB Communications Hub and main unit. Install batteries in the remote sensor before installing the USB Communications Hub and main unit. Secure the sensor in the desired location using the wall mount bracket. 5 EN EN · Position the sensor so that it faces the USB Communications Hub and main unit, minimizing obstructions such as doors, walls and furniture. Place the sensor in a location with a clear view to the sky, away from metallic / electronic objects. Position the sensor close to the USB Communications Hub and main unit during cold winter months as belowfreezing temperatures may affect battery performance and signal transmission. · · · TIP The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results. NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing. SET UP USB COMMUNICATIONS HUB NOTE Set up the remote sensor before installing the USB Communications Hub. For continuous use, always connect the USB Communications Hub to the computer using the USB cable provided. 6 There is a registration mode with the main unit when the USB Communications Hub is turned on the first time, or after each installation. To register with the main unit: · · Press and hold SEARCH at the back of USB Communications Hub to enter registration mode. at the back of main unit to SET UP MAIN UNIT NOTE Set up the remote sensor and USB Communications Hub before installing the main unit. NOTE Batteries should not be exposed to excessive heat such as sunshine or fire. 3. Click on "Screen Saver" Tab in the Display Properties window. [. . . ] A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service. COUNTRIES RTTE APPROVAL COMPLIED All EU countries, Switzerland CH and Norway N EN EN · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio / TV technician for help. DECLARATION OF CONFORMITY The following information is not to be used as contact for support or sales. [. . . ]