User manual OREGON EMR201

[. . . ] LOCATION Indoor temperature area Outdoor temperature area MEANING Main unit batteries low Sensor batteries low · Wireless Indoor and Outdoor Thermometer with LED Ice Alert Model: EMR201 USER MANUAL OVERVIEW FRONT VIEW · · · REMOTE SENSOR To set up the sensor: 1. Place the sensor within 30 m (98 ft) of the main unit using the table stand or wall mount. [. . . ] 19861 SW 95th Ave. , Tualatin, Oregon 97062 USA 1-800-853-8883 NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice. 1 OUT TEMP SPECIFICATIONS 2 TYPE MAIN UNIT LxWxH DESCRIPTION 66 x 27. 5 x 87. 5 mm (2. 59 x 1. 08 x 3. 44 in) 241 g (8. 5 oz) without battery -5°C to 50°C (23°F to 122°F) 0. 1°C (0. 2°F) 433 MHz 25% - 95% 1% 2 x UM-4 (AAA) 1. 5 V batteries 96 x 50 x 22 mm (3. 78 x 1. 97 x 0. 87 in) 62 g (2. 22 ounces) IN TEMP 3 Weight Temperature range 4 Resolution Signal frequency declare that the product Product No. : EMR201 Product Name: Wireless Indoor and Outdoor Thermometer with LED Ice Alert Manufacturer: IDT Technology Limited Address: Block C, 9/F, Kaiser Estate, Phase 1, 41 Man Yue St. , Hung Hom, Kowloon, Hong Kong is in conformity with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. 1. 4. Remote sensor reception indicator Outdoor temperature Indoor temperature Ice alert LED indicator Humidity range Humidity resolution NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing. The sensor reception icon in the remote sensor area shows the status: ICON OUT Power BACK VIEW REMOTE UNIT (THN132N) LxWxH Weight Transmission range 30 m (98 ft) unobstructed Temperature range Power -20°C to 60°C (-4°F to 140°F) 1 x UM-3 (AA) 1. 5 V batteries 1 2 RESET C/ F OUT OUT OUT OUT OUT OUT DESCRIPTION Main unit is searching for sensor(s). The sensor cannot be found. ABOUT OREGON SCIENTIFIC Visit our website (www. oregonscientific. com) to learn more about Oregon Scientific products. If you're in the US and would like to contact our Customer Care department directly, please visit: www2. oregonscientific. com/service/support OR Call 1-800-853-8883. For international inquiries, please visit: www2. oregonscientific. com/about/international TIP The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results. °C / °F: Select temperature unit RESET: Reset unit to default settings ICE WARNING If the channel 1 sensor falls between 3°C to -2 °C (37°F to 28°F), LED indicator will flash, and will stop flashing once the temperature is out of this range. REMOTE SENSOR FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] 5. LED status indicator Wall mount hole Battery compartment RESET hole CHANNEL switch · · · GETTING STARTED INSERT BATTERIES 1. Press RESET after each battery change. · · © 2007 Oregon Scientific. [. . . ]