User manual NOKIA BLUETOOTH STEREO HEADSET BH-505

[. . . ] Also, read the user guide for the device that you connect to the headset. Keep them out of the reach of small children. Note: The surface of this device does not contain nickel in the platings. The surface of this device contains stainless steel. without cables. The headset and the other device do not need to be in line of sight, but they should be within 10 metres (33 feet) of each other. [. . . ] If your mobile device supports the A2DP Bluetooth profile and has a music player feature, you can use the device to also play music through the headset. If your mobile device does not support the A2DP profile, you can separately pair the headset with the mobile device and a music player that supports this profile. If you have paired and connected the headset to your mobile device, disconnect the headset from it before pairing the headset with the music player. To pair and connect the headset to your device if the device supports the Near Field Communication (NFC) feature, activate the feature, and use your device to touch the area shown in figure 10 at the start of this guide. To pair and connect the headset to your device if the device does not support NFC: 1. Ensure that your mobile device or music player is switched on and the headset is off. If the headset has not been previously paired with a device, switch on the headset. The headset enters pairing mode, and the blue indicator light starts to flash quickly. If the headset has been previously paired with a device, ensure that the headset is switched off, and press and hold the power key (for about 8 seconds) until the blue indicator light starts to flash quickly. ENGLISH 3. Within about 3 minutes, activate the Bluetooth feature on your device, and set it to search for Bluetooth devices. If necessary, enter the passcode 0000 to pair and connect the headset to your device. If your device does not have a keypad, it may use this passcode by default. In some devices, you may need to make the connection separately after pairing. When the headset is connected to your device and is ready for use, the blue indicator light flashes slowly. You can pair the headset with up to eight devices but connect it to only one device supporting the HFP profile and another device supporting the A2DP profile at a time. To manually connect the headset to a last used device that supports the HFP profile (for example, after connection loss), switch the headset off and on, or press and hold the answer/end key for about 2 seconds. To manually connect the headset to a last used device that supports the A2DP profile, press the play/pause key. You may be able to set your device so that the headset connects to it automatically. To activate this feature in a Nokia device, change the paired device settings in the Bluetooth menu. ENGLISH Basic use Change the earplugs The headset may be provided with different sized earplugs and earpads. Select the earplugs or earpads that fit the best and are the most comfortable for your ears. To change the current earplugs, pull them from the earpieces, and push the new earplugs or earpads into place. Warning: When you use the headset, your ability to hear outside sounds may be affected. Do not use the headset where it can endanger your safety. Adjust the volume To adjust the headset volume, slide the volume key up or down when the headset is connected to a device. [. . . ] The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. ENGLISH If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. These suggestions apply equally to your device, charger, or any accessory. [. . . ]