User manual NOKIA BLUETOOTH SPEAKERS MD-7W

[. . . ] Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. Unauthorized changes or modifications to this device may void the user's authority to operate the equipment. Export Controls This device may contain commodities, technology or software subject to export © 2007 Nokia. [. . . ] The speakers comply with the Bluetooth Specification 2. 0 + EDR that supports Advanced Audio ENGLISH Distribution Profile (A2DP) 1. 0 and Audio/Video Remote Control Profile (AVRCP) 1. 0. Check with the manufacturers of other devices to determine their compatibility with this device. Getting started Parts The speakers contain the parts shown on the title page: power and Bluetooth indicator light (1), power key (2), speakers (3), volume key (4), stereo widening key (5), indicator light for stereo widening (6), power connector (7), audio connector (8), and speaker connection cord (9). Parts of the speakers are magnetic. Do not place credit cards or other magnetic storage media near the speakers, because information stored on them may be erased. Chargers Check the model number of any charger before use with this device. This device is intended for use when supplied with power from the AC-4 charger. Warning: Use only chargers approved by Nokia for use with this particular device. The use of any other types may invalidate any approval or warranty and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Connect to power The speakers can be powered by the supplied charger or four AA batteries. ENGLISH Connect to wall outlet To use the speakers with the charger, connect the charger to a wall outlet, and plug the charger cable to the power connector. If you use rechargeable batteries with the speakers, the batteries are not charged by the charger. Install AA batteries To install the batteries, ensure that the speakers are switched off, and press the release switch of the battery cover at the back of each speaker. To close the cover, insert the catch at the top of the cover into the corresponding slot on the speaker, and push the cover against the speaker until it snaps into place. During long periods where the speakers are not used, remove the batteries to prevent damage from battery leakage. When battery power is low, the orange indicator light starts to flash, and the speakers beep. Switch the speakers on or off To switch on, press and hold the power key until the white indicator light turns on. The orange indicator light is briefly displayed. Connect the speakers You can connect the speakers to a compatible music device (such as a music player or mobile phone with a music player feature) using Bluetooth wireless technology or the supplied cable. To use a Bluetooth connection, the music device must support the A2DP Bluetooth profile. ENGLISH Pair and connect using Bluetooth wireless technology The following instructions apply for a mobile phone but the procedure is the same for a music player, except that you may not need to give the Bluetooth passcode. Press and hold the power key until the white indicator light starts to flash. Activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices. Enter the Bluetooth passcode 0000 to pair and connect the speakers to the phone. In some phones you may need to make the connection separately after pairing. If the pairing is successful and the speakers are in a Bluetooth connection with the music device, the white indicator light flashes about every 4 seconds. Connect using a cable You can connect the speakers to a compatible device with the supplied CA-63U cable. [. . . ] · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. If the product is not working properly, take it to the nearest authorised service facility for service. Disposal The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. ENGLISH This requirement applies to the European Union and other locations where separate collection systems are available. By returning the products to collection you help prevent uncontrolled waste disposal and promote the reuse of material resources. [. . . ]