User manual NOKIA BH-602

[. . . ] Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. Contents Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Bluetooth wireless technology. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The headset is intended for use with the AC-3, AC-4, and DC-4 chargers. Warning: Use only chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Charge the battery The headset has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the headset, as you may damage the headset. Connect the charger to a wall outlet. Charging the battery for 15 minutes provides about 5 hours of talk time with the AC-4 charger. Charging the battery fully may take up to 45 minutes with the AC-4 charger. The fully charged battery has power for up to 11 hours of talk time or up to 300 hours of standby time. However, the talk and standby times may vary with different compatible Bluetooth devices, usage settings, usage styles, and environments. To check the battery charge when the headset is not connected to a charger, briefly press the power key. When the indicator light is green (displayed for about 3 seconds), the charge level is sufficient. If charging does not start, disconnect the charger, plug it in again, and retry. Get started may need to recharge the battery soon. When battery power is low, the headset beeps at regular intervals, and the indicator light slowly flashes red. Switch the headset on or off To switch on, press and hold the power key until the headset beeps and the green indicator light is displayed. When the headset tries to connect to a paired device, the indicator light slowly flashes green. When the headset is connected to a paired device and is ready for use, the indicator light slowly flashes blue. If the headset has not been previously paired with a device, it automatically enters the pairing mode (see "Pair the headset, " p. To switch off, press and hold the power key until the headset beeps and the red indicator light flashes once. Pair the headset 1. Ensure that your mobile device is switched on. 10 Get started To pair the headset if it has been previously paired with another device, ensure that the headset is switched off, and press and hold the power key until the indicator light starts to flash blue quickly. Activate the Bluetooth feature on the mobile device, and set it to search for Bluetooth devices. Enter the passcode 0000 to pair and connect the headset to your device. In some mobile devices, you may need to make the connection separately after pairing. If pairing is successful, the headset appears in the menu of the mobile device where you can view the currently paired Bluetooth devices. [. . . ] Batteries may also explode if damaged. 20 Care and maintenance Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. [. . . ]