User manual NIKON SCAN 3.1.4 FOR MAC OS X SPECIAL NOTES

[. . . ] Please save your image files to your local hard disk first, and then move them to your network volume later on. PICT file cannot be opened (Mac OS X only) This release of Nikon Scan cannot open PICT format files although it saves files in PICT format correctly. System Sleep Issue (Mac OS X only) Please turn off the computer "Sleep" setting if you use LS-8000ED or LS- 4000ED. [. . . ] This tag is normally applied when the Color Management System is turned on, however Nikon Scan will not embed an ICC profile tag when the "Scanner RGB" is selected, even if the color management system is turned on. · III. Using a SA-20, SA-21 Strip Film Adapter or SA-30 Roll Film Adapter The following sections describe tips for the SA-20, SA-21 and SA-30 film adapters. Frame Boundary Nikon Scan will automatically detect the edges of each frame. Positive Film Type selected for a strip of negative images), this auto detect operation may not work properly. Please make sure that the Film Type is set correctly prior to performing any scans. Additionally, the thumbnail scan is an important step in aligning multiple frames for preview and main scans, and should be performed at least once prior to doing any preview scans or main scans. If it is not possible to perform a thumbnail scan, a preview scan should be performed as a minimum requirement. Frames with dark images or content can cause problems with frame edge detection. If the image appears to be offset, please use the "Adjust Boundary Offset" controls, located within the "Extras" tab, to change the scan offset. Continue to take preview scans until a satisfactory result is obtained. Differences between thumbnail images and preview images There is a slight difference between the thumbnail scan coverage area and the preview/main scan coverage area. As this is only a slight difference, there should be little or no consequences in the use of the scanner. The preview scan area, as well as the main scan area, covers slightly more area at the top and bottom of the images than the thumbnail scan area. The preview scan as well as the main scan area covers slightly less area at the top and bottom (when film is displayed vertically) of the images than the thumbnail scan area. Thumbnail display issue when using SA-30 Roll Film Adapter A thumbnail image for the 40th frame might not be displayed when using a filmstrip that contains 40 frames or more. Please consult the section called "scanning short, long or damaged film strips" in the User Manual. [. . . ] Switching the Nikon Color Management system It is necessary to quit and to re-launch Nikon Scan 3 after turning the Color Management System on or off for the change to take effect. Making the most of available memory Please note following techniques that can be tried in order to minimize memory usage: · Reduce the number of preview images. · When using the IA-20 (Advanced Photo System) adapter, do not use the thumbnail display, use the index print supplied with the developed film instead. [. . . ]