User manual NIKON MC-EU I

[. . . ] Refer to the Nikon Guide to Digital Photography for more information on the operations performed when the shutter-release button is fully pressed. Remove the battery if you will not be using the product for a long period of time. When devices that emit electromagnetic radiation or noise, such as cellular telephones, are in the immediate vicinity, communication between the remote cord and the camera may be disrupted, causing the camera to stop responding to remote cord operations. [. . . ] After adjusting settings, press the selection button until the display is no longer flashing. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. CAUTIONS Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Nikon Corporation may void the user's authority to operate the equipment. Le câble de télécommande dispose de trois modes de fonctionnement : un "mode à distance" qui sert à commander l'appareil photo à distance et deux "modes Intervallomètre" (Mode Intervalle A et Mode Intervalle B) que l'on peut utiliser lors de prises de vue automatisées. Refer to the Nikon Guide to Digital Photography provided with your camera for more information on the operations performed when the shutter-release button is pressed halfway. If the interval is set to less than two minutes when the shutter-release button is half-pressed, the interval display will flash. Refer to the Nikon Guide to Digital Photography for more information on the operations performed when the shutter-release button is fully pressed. When the camera enters interval mode, it will either take a picture and then begin the count to the next photograph (Interval Mode A), or begin the count to the first photograph (Interval Mode B). The remote cord's LCD display shows current settings for the remote cord, together with camera status (Figure 3). While data are being recorded to the camera's memory card, the message *Busy will be displayed. [. . . ] If you are still unable to determine the cause of the problem, request servicing from your retailer or local Nikon Service Bureau. Any repairs made during the warranty period are free of charge provided the terms of the warranty agreement are fulfilled. For more information, refer to the warranty card provided with this product. [. . . ]