User manual NIKON EH-31

[. . . ] Sections marked with this symbol should be read before use to ensure that the product continues to operate properly. connecting the AC Adapter Before connecting the AC adapter , be sure the camera is off. Follow these steps to connect the adapter (see Figure B): 1 Plug the power cable into the AC adapter. [. . . ] Federal Communications Commission (FCC) Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. consult the dealer or an experienced radio/television technician for help. CAUTIONS Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Nikon Corporation may void the user's authority to operate the equipment. Interface Cables Use the interface cables sold or provided by Nikon for your equipment. Using other interface cables may exceed the limits of Class B Part 15 of the FCC rules. Cautions Improper use of the EH-31 could result in fire or electric shock. â· Be sure to use a voltage appropriate to the cable provided with your adapter. Should you notice smoke or an unusual smell or noise coming from the adapter, immediately turn the camera off and then unplug the power cable from the power source. After confirming that the adapter is no longer smoking, take it to a Nikon-authorized service center for inspection. Be careful not to damage the power cable's protective insulation. Do not cut or abrade the cable, expose the cable to heat or flame, or place heavy objects on the cable. When removing the cable from a power outlet, pull on the plug; never pull directly on the cable itself. Should the cable be damaged, return it to your retailer for a replacement. [. . . ] â· While Nikon has made every effort to produce perfect manuals, we appreciate any opportunity for improvement. Should you find any mistakes, we would be grateful if you were to kindly let us know. The address of Nikon's representative in your area is provided separately. [. . . ]