User manual MULTICOAT SLATEX ABOVE GRADE

[. . . ] SPEED BOND is used to repair cracks, holes, and depressions prior to the application of Krete Kote, Slatex or Scratch Kote Systems. [. . . ] Once opened, all cracks must be cleaned by sandblasting, waterblasting or water sandblasting. NOTE: Cleaning out prepared cracks may be done in conjunction with substrate preparation (See Krete Kote / Slatex Systems). IMMEDIATELY SPREAD WITH 4" PLASTIC PUTTY KNIFE APPLICATION Fill properly prepared cracks with SPEED BOND material. Backer rod or sand should be placed in cracks where depths are greater than 3/8". Inject SPEED BOND material into crack, level with the surface of the substrate. Seller's sole obligation shall be to replace material if found to be defective. Seller shall not be liable for any damages, injury, loss, direct or indirect or consequential, resulting from use of its products. PACKAGING AND STORAGE SPEED BOND is furnished in a 12 oz. Note: A special caulking gun needs to be purchased to properly dispense SPEED BOND. Caulking guns are readily available through Multicoat or your local Multicoat Distributor. TEST DATA: SPEED BOND TEST CONDITIONS TEST METHOD PROPERTIES 1. [. . . ] -40° to 121° C M TICO UL MULTICOAT CORPORATION West Coast Toll Free: (877) MULTICO (685-8426) (949) 888-7100 FAX (949) 888-2555 website: www. multicoat. com E-mail: multi5000@aol. com MULTICOAT PRODUCTS, INC. [. . . ]