User manual MOULINEX ODACIO

[. . . ] - Any operations other than the usual cleaning and care by the customer must be carried out by an approved MOULINEX service centre (see list in the service manual). - Do not place the appliance, the power cord or the plug in water or any other liquid. - The power cord must not be placed close to or in contact with the hot parts of your appliance, close to a source of heat or over a sharp edge. In order to avoid any danger, have them replaced by an approved MOULINEX service centre (see list in the service manual). [. . . ] To make the tap (k6) easier to clean, it can be dismantled into two parts: Press " push ", and release the cover (fig. Fit the cover by pressing the middle of it, then clip on the metal pin underneath the hooks (fig. FITTING THE ACCESSORIES Press the release button (a4) to open the upper drive cover (a1). You should hear it click shut Push the seal (k5) as far as possible onto the neck of the jug, then lock the assembled tap (k6 with a quarter turn). Tips : this blender, fitted with its tap, allows you to pour your preparation, directly into glasses (cocktails), onto plates or into bowls (soups) or into the pan (pancakes). Speed 1 helps you to serve thick preparations (milkshakes or smoothies). If you do not need the tap, you can replace it with the stopper (k7) (see fig 6a-1), equipped with the seal (k5). - Place the ingredients in the blender (k3), then lock the lid (k2) onto the jug. Tips You can add ingredients via the hole of the cap (k1) during the preparation. - Do not use the blender with dry foodstuffs (walnuts, almonds, peanuts. Speed To remove the blender, hold it by the handle and press the release button (a4). - Grapes, quinces or redcurrants: to obtain better results, clean the filter after every 300g of ingredients. - Important: When the pulp collector is full , stop the appliance , and empty the collector. - Wait until the rotary filter has completely stopped before removing the assembly To remove the centrifugal juice extractor (m5), press the release button (a4), and lift off the assembly. VEGETABLES (depending on model) ACCESSORIES USED Centrifugal juice extractor with pouring spout (m) or Bowl (b3) and centrifugal juice extractor with filter basket (m) FITTING THE ACCESSORIES Spout (m5) Press the release button (a4) to open the upper drive cover (a1). Place the filter (m3) in the centre of the pulp collector (m4), turn and lock the lid (m2) onto the pulp collector (m4). Hold the locking lever (m6) in the closed padlock position then fit the assembly, onto the upper drive (a2). Tips - Insert the foodstuffs into the tube and press them down slowly using the food pusher (m1). - Chop the fruits into pieces and place a large glass underneath the spout (m5). 5 kg of fruits (apples, carrots, grapes) 5 times consecutively, without allowing your appliance to cool down completely. Assemble the filter basket (m10) with its filter crown (m9): lower it into the filter basket to clip it onto the assembly. - Lower the filter basket assembly (m9+m10) onto the bowl drive (b3-1) - Fit the lid (m8) onto the bowl. [. . . ] - To make cleaning and storage easier, the handle of the bowl (b4) and that of the blender (k4) can be removed (they are dishwasher proof). - In the event of your accessories being stained by foodstuffs (carrots, oranges. - Do not place the motor unit (a), the whisk drive body (f1), or the geared reducer (n) in water or under running water. - a cord storage recess inside the motor unit: Store and adjust the length of the power cord to suit your requirements by pushing or pulling the cord. [. . . ]