User manual MOULINEX MO5396PA COMPACTEO ERGO CYCLONIC

[. . . ] To avoid danger, the whole reel and power cord unit of your vacuum cleaner must be replaced by a Moulinex Approved Service Centre. REPAIRS Repairs are to be performed only by specialists with original spare parts. A – Vertical carry grip b – Mobile horizontal handle for carrying 7. Dust compartment a – Grip zone b – Lid c – Compartment lid opening clips d – HEPA filter capsule opening clips 14. [. . . ] 14 • Remove the dust compartment (13) from its housing (7) using the grip zone (13a) - fig. EMPTY THE DUST COMPARTMENT Empty the dust compartment (13) after each use. €¢ Pull the dust compartment opening clip (13c) to open it - fig. €¢ Make sure no dust is left in the compartment, then wipe the edges of the compartment - fig. €¢ Close the dust compartment (13) and replace it in its housing (7) - fig. To optimise the efficiency of your vacuum cleaner, make sure you clean the foam (14a) each time you empty the dust compartment (13). €¢ Simultaneously pull on the HEPA filter capsule opening clips (13d) - fig. €¢ Separate the black foam filter (14a) from the HEPA filter (14b) - fig. €¢ Wash the black foam filter (14a) under the tap, squeeze it out like a sponge and leave to dry for 12 hours - fig. €¢ Once completely dry, assemble the HEPA filter capsule (14): black foam filter (14a) and HEPA filter (14b) under the dust compartment (13) - fig. The black foam filter (14a) should only be put back into the appliance when it is completely dry. You can use your vacuum cleaner while the black foam filter (14 a) is drying by using the replacement black foam filter: (14a bis). CLEAN THE DUST COMPARTMENT (13) AND THE AIR/DUST SEPARATOR (15) Important: Clean the dust compartment (13) and the dust separator (15) every month. €¢ Pull the dust compartment opening clip (13c) to open it - fig. 18a, unclip the HEPA filter capsule (14) by simultaneously pulling on the opening clips (13d) located at each end of the compartment - fig. €¢ Turn the compartment over and place the accessory* (18b) into the lock slot of the dust separator holder (17) - fig 20. €¢ Open, making sure you respect the unlocking direction ( ) - fig 21. €¢ Unclip then remove the dust separator (15) in the unlocking direction ( ) - fig-23. €¢ Then run the dust compartment (13), dust separator holder (16) and the dust separator (15) under clear or soapy water - fig 24a. €¢ Once dry, replace then clip the dust separator (15) on the dust separator holder (16), in the locking direction ( ) - fig 25. €¢ Place the accessory* (18b) into the lock slot of the dust separator holder (17) - fig 20. 8 * According to model: these systems are specific to certain models or are accessories available as an option. [. . . ] THE ACCESSORIES* ACCESSORIES* Furniture tool Slot tool attachment convertible into a brush Hardfloor tool Mini turbobrush Turbobrush USE To clean furniture For corners and areas which are difficult to reach For fragile floors. FITTING OF THE ACCESSORY Fit the furniture tool to the end of the tube. Fit the slot tool attachment convertible into Moulinex Authorised Service a brush to the end of the grip or the tube. Centres (To find a list of Authorised Service Fit the hardfloor tool to the end of the tube. [. . . ]