User manual MOULINEX MO 4011

[. . . ] € Unplug the appliance by removing the plug from the power outlet: - immediately after use, - before changing accessories, - before maintenance, cleaning or changing the dustbag. Vacuum cleaner supply cords and winding systems must, in all cases, be replaced by our approved Service Centre. Repairs should only be carried out by specialists using original replacement parts. A - Horizontal parking b - Upright parking On/Off pedal Electronic power control Automatic cable rewind pedal Bag fill indicator Air exit grill Carrying handle Bag compartment Cover Suction opening Lip opening door Engine foam-filter protection Engine foam-filter grill protection HEPA filter cartridge* ref. [. . . ] - With the electronic power regulator on the power nozzle: open the selector switch flap to manually reduce suction power regulator, ex: fragile surfaces… - fig. STORING AND TRANSPORTING THE APPLIANCE • After use, stop your appliance by pressing on the on/off pedal (2) and unplug it - fig. Replace the cable by pressing the automatic cable rewind pedal (4) - fig. € In an upright position, hook the telescopic tube* (20) onto its storage position on the back of the appliance (1b) - fig. € You can transport your vacuum cleaner easily using its carrying handle (7). € In the horizontal position, hook the floor nozzle (23) onto its storage position at the rear of the appliance (1a) - fig. PLUGGING IN THE ELECTRICAL POWER CORD AND USING THE VACUUM CLEANER • Completely unwind the power cord, plug in your vacuum cleaner - fig. CHANGING THE BAG GB I E P SA FA TR • The bag capacity indicator (5) tells you when the bag is full or saturated. If you notice that your vacuum cleaner is less efficient, select the maximum power and by lifting the floor head off the floor. € Fit a fresh bag, position it using the tongue provided and clip it onto the bag support - fig. € Make sure that the bag is in the correct position before closing the lid (9). 2- The microfilter cassette* • Open the lid (9) of your vacuum cleaner fig. € Withdraw the microfilter cassette* (15) • Separate the grey foam filter (15b) from the microfilter (15a). € Dispose of the microfilter (15a) in a waste bin and replace it with a new Microfilter (ref. € Wash the grey foam filter (15b) with warm soapy water (mild detergent). Caution: Make sure that the grey foam filter is completely dry before putting it back in place. € Check that the microfilter cassette* (15) is fitted correctly before re-closing the lid (9). CLEAN THE VACUUM CLEANER • The motor foam-filter protection (12) must always be in place when in use. € Shake it and clean it, every ten dustbag changes, with tepid soapy water. € Let the foam-filter dry (12) completely before putting back in place. Make sure that the foam filter is completely dry before fitting it again. € Clean the housing of the vacuum cleaner with a soft and humid rag and let dry. [. . . ] Any professional use, innapropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. € Read the instructions for use carefully before using your appliance for the first time: any use which does not conform to these instructions will absolve Moulinex from any liability. 12 NoticeZÉLIO 7/06/07 14:43 Page 13 F THE ACCESSORIES* ACCESSORIES* Floor nozzle For hard and smooth floors. VACUUMING FITTING AN ACCESSORY PURCHASE LOCATIONS Moulinex Approved Ser vice Centres (see the attached address list). [. . . ]