User manual MOULINEX MO3723PA POWER CYCLONIC

[. . . ] Turn the tube 90 degrees anti-clockwise again to position the nozzle breadthwise and to make the brush strip disappear into the nozzle housing. 9) 4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean small soft floor areas. Turn the tube 90 degrees anti-clockwise again until it is positioned lengthwise with the brush strip still folded in. 1 To connect the hose, push it firmly into the appliance (you will hear a click). [. . . ] Connect the tubes to the handgrip by inserting the narrow section into the wider section while turning it a little. 2) To disconnect the tubes from the handgrip, pull while turning a little. Connect the tube to the handgrip by pressing the spring-loaded lock button on the handgrip and inserting the handgrip into the tube. Fit the spring-loaded lock button into the opening in the tube ('click'). 3) To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the handgrip out of the tube. Crevice tool, small nozzle and small brush 1 Connect the crevice tool (1), the small nozzle (2) or the small brush (3) directly to the handgrip or to the tube. The crevice tool and small nozzle can be stored in the accessory holder by pushing them into the holder. 13) Please note the way in which the small nozzle must be placed in the accessory holder. Instead of the small nozzle, the small brush can be stored in the accessory holder by pushing it into the holder. With the infrared remote control you can set the suction power to one of 5 different suction power settings. When you switch the appliance on, it will always start running at the highest suction power setting. 1 Replace the HEPA Filter as soon as the pilot light of the filter-full indicator goes on (specific types only). The HEPA filter can be replaced in the same way as the AFS Micro Filter. Every time you empty or replace the dustbag, clean the Permanent Motor Protection Filter. 2 Take the Motor Protection Filter holder out of the appliance and clean the filter by shaking it over a dustbin. 27) 3 Press the filter holder with the clean filter firmly into place to ensure that it fits properly at the bottom. 28) 4 Place the dustbag holder with the dustbag back into the appliance. AFS Micro Filters are available under type number FC8030 (432200492910). Activated Carbon Filters are available under type number FC8033 (482248020145). Instead of with the Motor Protection Filter, some appliances are equipped with an Activated Carbon Filter. Replace the Activated Carbon Filter every 6 months or when you notice that smell absorption becomes less effective. If you have any difficulties obtaining dustbags, filters or other accessories for this appliance, 6 Remove the lid of the battery compartment to make sure that the - and + poles are pointing in the right direction. [. . . ] If you have any difficulties obtaining dustbags, filters or other accessories for this appliance, 6 Remove the lid of the battery compartment to make sure that the - and + poles are pointing in the right direction. To make recycling opssible, the plastics used for this appliance have been coded. the cardboard packaging has been made of recycled materil and is fully recyclable. Types with an infrared remote control only: remove the batteries when you discard the appliance. [. . . ]