User manual MOULINEX MO2524PA

[. . . ] €¢ Do not use the appliance if it has been dropped and there is visible damage to it, or if it fails to function normally. In this case, do not open the appliance but send it to the nearest Approved Service Centre or contact Moulinex Customer Services. Electric power source • Check that your vacuum cleaner voltage corresponds to that of your domestic power supply: you will find this information on the appliance. €¢ Switch off and unplug the appliance: - immediately after each use, - before every change of accessories, - before every cleanup or maintenance procedure, and before changing the filter. [. . . ] €¢ Transport your vacuum cleaner easily thanks to its transport handle (6). CLEANING AND MAINTENANCE Important: Always switch off and unplug your vacuum cleaner before maintenance or cleaning. Warning: remember to stand over a bin every time you clean the dust tray. Remove the dust tray (13) • Withdraw the tube (19) from the vacuum opening (10) - Fig. €¢ Remove the dust tray (13) from its housing (7) : take the tray handle (13a) and remove the tray – fig. EMPTY THE DUST TRAY Important: Empty the dust tray (13) after each use. €¢ Place the lid back: place the stops in their slots – fig. €¢ Replace the tray (13) in its compartment (7) – Fig. To optimise the performance of your vacuum cleaner, make sure you clean the foam (14a) each time you empty the dust tray (13). €¢ Pull simultaneously on the opening clips (13d) of the HEPA filter case - Fig. €¢ Separate the black foam filter (14a) from the HEPA filter (14b) - Fig. €¢ Wash the black foam filter (14a) under the tap, squeeze it out like a sponge and leave to dry for 12 hours fig. *Depending on model: it means special equipment for some models or optional accessories. 9 903398-01_MO25_city-space-cyclonic_903398/01 11/07/13 09:51 Page10 • Once the foam is completely dry, assemble the HEPA filter case (14): black foam filter (14a) and HEPA filter (14b) under the dust tray (13) – Fig. 22, then replace the dust tray inside its compartment (7) – Fig. The black foam filter (14a) should only be put back into the appliance when it is completely dry. You can use your vacuum cleaner while the black foam filter (14a) is drying by using the replacement black foam filter (14abis). CLEAN THE DUST TRAY (13) AND THE AIR/DUST SEPARATOR (15) Important: Clean the dust tray (13) and the dust separator (15) every month. €¢ Unlock the HEPA filter case (14) by simultaneously pulling on the opening clips (13d) located at either end of the dust tray – Fig. €¢ Turn the compartment over and place the accessory (18b) into the lock slot of the air/dust separator base (17) - fig 26. €¢ Open, making sure to turn in the proper sense for unlocking ( ) – Fig. €¢ Unclip then remove the air/dust separator (15) by turning it in the unlocking direction ( ) – Fig. [. . . ] EN Cleaning the vacuum cleaner • Wipe the body of the vacuum cleaner and accessories with a soft damp cloth, then dry. €¢ Do not use any detergents, or corrosive or abrasive products. TROUBLESHOOTING Important: If you notice that your vacuum cleaner is not operating well, switch it off using the ON/OFF pedal before carrying out any checks. If your vacuum cleaner will not start • The appliance is not plugged in : check that the appliance is correctly plugged in. [. . . ]