User manual MOULINEX MO2125

[. . . ] Vacuum cleaner supply cords and winding systems must, in all cases, be replaced by our approved Service Centre. Repairs Repairs should only be carried out by specialists using original replacement parts. Microfilter cassette* a - Microfilter b - Grey foam filter Your vacuum clamer is equipped either with microfilter cassette* (a+b), or with a HEPA filter cartridge*. [. . . ] In the horizontal position, hook the floor nozzle (25) onto its storage position at the rear of the appliance (1a) - fig. 10 *Depending on model: it means special equipment for some models or optional accessories. iFU_MO_ASPIRATEUR_POWER-SPACE_903174_Mise en page 1 07/06/12 14:46 Page11 CLEANING AND MAINTENANCE 1. Changing the bag The bag capacity indicator (5) tells you when the bag is full or saturated. If you notice that your vacuum cleaner is less efficient, select the maximum power and by lifting the floor head off the floor. Fit a new bag, positioning it by means of the tab and reclip it back on to the bag support frame - fig. Make sure that the bag is in the correct position before you close the lid (9). Your vacuum cleaner is also compatible with the Wonderbag Compact bag ref. B) If your vacuum cleaner is fitted with a textile bag* (17): Remove the bag support frame from the bag compartment (18) - fig. 16a, then remove the textile* bag from its support by sliding it along the runners. Clean the bag using clean water Leave it to dry for at least 24 hours (only put the bag back in when it is completely dry). Cleaning the foam filter for protection of the motor The foam filter protecting the motor (12) must always remain in place during use. Shake it and clean it, every ten dustbag changes, with tepid soapy water. Rinse it and leave it to dry for at least 12 hours before putting it back. Attention: ensure that the foam filter is properly dry before putting it back. Change the HEPA filter capsule*, the washable HEPA filter capsule* or the micro filter capsule* every 10 times you change or clean the bag 3. 1- The Hepa* filter cassette Open the lid (9) of your vacuum cleaner - fig. Check that the Hepa* filter cassette (15) is fitted correctly before re-closing the lid (9). [. . . ] Pull the cable back out and press on the automatic cable rewind pedal. If you have any product problems or queries, please contact our customer Relations Team first for expert help and advice. Any professional use, innapropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. [. . . ]