User manual MOULINEX MO1825

[. . . ] Keep your guarantee certificate safely and read carefully the instructions for use before using your appliance. TIPS AND PRECAUTIONS • Before each use, the cable must be unravelled completely. €¢ If you use an extension cable, make sure it is in perfect condition, and that it is suitable for the power requirements of your vacuum cleaner. €¢ Do not move the vacuum cleaner by pulling on the cable. [. . . ] €¢ To withdraw it, turn in the opposite direction and pull - fig. €¢ If your vacuum cleaner is equipped with a telescopic tube * (18) : push the adjustment button forward, pull out take out the desired length of tube, and then release the button to lock it in position. - For carpets and rugs, use the all floor nozzle (21) with the brush in the retracted position. - For parquets and smooth floors : use the all floor nozzle (21) with the brush extended - fig. - For corners and areas which are difficult to reach : use the convertible crevice tool * (23) in the flat suction position. - For furniture : use the brush of the convertible crevice tool * (23) or the upholstery nozzle * (22). Always switch off and disconnect your vacuum cleaner before changing accessories. * According to model: this is either equipment specific to certain models or available as an optional accessory 902739_mini-space_902739 01/02/11 14:28 Page13 CONNECTING THE CABLE AND STARTING YOUR APPLIANCE EN • Unravel the cable completely, connect your appliance, - fig. €¢ Adjust the power of the vacuum : with the mechanical power adjustment : open the slider control to manually reduce the suction power, except on fragile surfaces - fig. STORING AND TRANSPORTING THE APPLIANCE • After use, stop the vacuum cleaner by pressing on the On/off pedal (2) and disconnect it. €¢ In the vertical position, place the all floor nozzle (21) in its storage position under the appliance (1b) fig. RS-RT9926) • Open the lid (8) of your vacuum cleaner fig. €¢ Place the pins of the new (H)EPA* filter cassette in the notches - fig 41. €¢ Adjust the new (H)EPA* filter cassette (13) in its compartment - fig. €¢ Make sure the (H)EPA* filter cassette (13) is properly positioned before closing the lid. CLEANING THE VACUUM CLEANER • Wipe the body of the appliance and the accessories with a soft damp cloth, then dry. TROUBLESHOOTING Important : As soon as your vacuum cleaner begins to work less well than usual, switch it off by pressing on the On/off pedal, before doing any checking. YOUR VACUUM CLEANER DOES NOT START • The appliance is not connected to a power supply . IF YOUR VACUUM CLEANER HAS NO SUCTION • An accessory or the flexible tube is blocked : unblock the accessory or the flexible tube. €¢ The lid is not properly closed : Check the positioning of the bag and close the lid again. iF YOUR VACUUM CLEANER LOSES SUCTION , MAKES NOISE , WHISTLES • An accessory or the flexible tube is partially blocked. €¢ The bag is full, or saturated with fine dust : replace the paper bag (16a), or empty the textile bag* (16b). [. . . ] IF THE SUCTION NOZZLE IS DIFFICULT TO MOVE • Open the regulator to turn down the power. IF THE CABLE DOES NOT COMPLETELY RETRACT • The cable is held back by something outside its entry point : straighten out the cable and press on the cable return pedal. * According to model: this is either equipment specific to certain models or available as an optional accessory 902739_mini-space_902739 01/02/11 14:28 Page15 If the problem persists, take your vacuum cleaner to the nearest Moulinex Approved Service Centre. consult the list of Moulinex Approved Service Centres , or contact Moulinex’s Consumer Services. [. . . ]