User manual MOULINEX MO 1521

[. . . ] Bag support runners * According to model: these systems are specific to certain models or are accessories available as an option. BEFORE USING FOR THE FIRST TIME UNPACKING • Unpack your appliance, keep your warranty card and read the instructions for use carefully before using your appliance for the first time. TIPS AND PRECAUTIONS • Before each use, the cord should be unwound completely. €¢ Make sure that it does not get stuck or go against sharp ribs. [. . . ] - For furniture: use the slot tool attachment convertible into a brush* (24) or the furniture nozzle* (23). €¢ Your appliance is equipped with a strap * (27), which allows you to carry it on your shoulder. - To unlock the strap, remove the covers on either side of the handle by giving them a quarter turn in the direction opposite to the arrow – fig. - To replace it, do the reverse: replace the covers on either side of the handle by giving them a quarter turn in the direction of the arrow – fig. 5b, until they click, and then place the shoulder strap in its storage housing (7b). Be sure to observe the assembly direction ( ) indicated close to the on/off pedal (2). Always stop and unplug your vacuum cleaner before changing accessories. CONNECTING THE CORD AND STARTING THE APPLIANCE • Unwind the power cord completely, plug your vacuum cleaner in – fig. €¢ Set the suction power: - using the electronic power regulator* (3): turn the switch on the electronic regulator* to set the suction power: towards maximum position for floors and minimum position for furniture and fragile fabrics – fig. - with the mechanical power regulator on the grip: open the slider on the grip to manually reduce suction power, e. STORING AND TRANSPORTING THE APPLIANCE • After use, stop your vacuum cleaner by pressing the On/Off pedal (2) and unplug it – fig. €¢ Lock the microfilter * behind the engine protection grid (12) – fig. €¢ Make sure the microfilter* (13) is properly in position before closing the lid (9). HEPA FILTER CASSETTE* (REF: MT0007 01) Important: Replace the HEPA filter cassette* MT0007 01 every 6 months (depending on the frequency of use). €¢ Open the lid (9) of your vacuum cleaner – fig. €¢ Make sure the HEPA filter cassette* (14a) is properly in position before closing the lid (9). This cleaning operation is reserved exclusively for the HEPA filter cassette * ref: MT0008 01 • Open the lid (9) of your vacuum cleaner – fig. €¢ Ensure that the HEPA filter cassette * (14b) is completely dry before replacing it. €¢ Lock the HEPA filter cassette* (14b) (Ref: MT0008 01) in its housing – fig. €¢ Make sure the HEPA filter cassette* (14b) is properly in position before closing the lid (9). CLEANING THE VACUUM CLEANER • Wipe the body of the vacuum cleaner and accessories with a soft damp cloth, then dry. €¢ Do not use detergents or any corrosive or abrasive products. [. . . ] Leave to cool down for 30 minutes before using the vacuum cleaner again. If the problem persists, take your vacuum cleaner to the nearest Moulinex Approved Service Centre. See the list of Moulinex Approved Service Centres or contact the Moulinex Consumer Service (see contact information on the last page). WARRANTY • This appliance is for domestic use only; in the event of inappropriate use that does not comply with the instructions, the company shall take no liability and the warranty shall be null and void. [. . . ]