User manual MOULINEX ME 4151

[. . . ] - Do not place the appliance, the supply cord or the plug in water or any other liquid. - The supply cord should never be near to or in contact with hot surfaces, near to a heat source or sharp edges. - For your own safety, only use the Moulinex accessories and spare parts suitable for your appliance. - For your safety, this appliance complies with applicable standards and laws: Low Voltage Directive Electromagnetic Compatibility Environment Materials in contact with foodstuffs. [. . . ] Note: this job is easier with two people, one to feed the appliance with mince, and the other to control the filling of the sausage skin. Make the sausages the required length by pinching and turning the sausage skin. To make a good quality sausage, take care to avoid trapping air when filling and make the sausages 10 to 15 cm long (separate the sausages by using a tie to make a knot). VEGETABLE CUTTER (H) Fitting (diagram 5 and 6): Facing the motor unit, which should be unplugged, insert the storage unit H1 inclined to the right, aligning the ears on the storage unit with the openings on the motor unit E. Insert the stem protruding from the storage unit H1 into the shaft of the motor unit E. Turn the feed tube of the storage unit H1 to the left until it reaches the stop. € Place the selected cone in the opening at the front of the storage unit H1. € Press once or twice on the start/stop button (D) to lock the cone (fig. € Insert the foodstuffs into the feed tube of the storage unit H1 (fig. € To change cone, turn the storage unit H1 by a quarter turn to the right, then turn it back to the vertical position (fig. Fitting the dicer attachment: • Place the chip slicer cone in the opening at the front of the storage unit H1. - To dismantle the mincer head A, remove the pusher C and the tray B, unscrew the nut A5, remove the screen A4, the cutter A3 and the screw A2. - Do not put the mincer head A in the dish washer (this applies to the body A1, screw A2, nut A5, cutter A3, and screens A4). 2) Vegetable cutter attachments: • The storage unit (H1), the pusher (H2), the cones (H3a, H3b, H3c, H3d, H3e, H3f) and the storage attachment (I) may be put in the top basket of the dish washer, using the "ECO" or "LIGHTLY SOILED" programme. € Handle the cones with care, as the blades of the cones are extremely sharp. € In the case of colouration of the plastic parts by foodstuffs such as carrots, rub with a cloth soaked in cooking oil, then proceed with normal cleaning. STORAGE: All of the cones (H3a, H3b, H3c, H3d, H3e) can be stored on the appliance. 14) and slide them into the opening at the front of the storage unit H1. The storage attachment I clips to the opening at the front of the storage unit H1 (fig. If your appliance still does not work, contact a Moulinex approved service centre(see the list in the service booklet). eND-OF-LIFE ELECTRICAL OR ELECTRONIC PRODUCTS Think of the environment!Your appliance contains valuable materials which can be recovered or recycled Leave it at a local civic waste collection point or to an approved service centre. [. . . ] Brown the garlic and coriander leaves in a frying pan for 1 to 2 minutes on low heat. Pour the yoghurt and cornflour mix into a saucepan through a fine sieve. Variant: You can also stuff the meatballs (with a mixture of onion and minced meat, browned in a little oil with a few pine nuts. ) PIROJKI small fish pasties) 4 people – Preparation: 25 min. [. . . ]