User manual MOULINEX LM850D10 MASTERMIX

[. . . ] SAFETY LOCKING The appliance can run only when the blender jug assembly (C) is correctly positioned on the motor unit (A). USING FOR THE FIRST TIME • Before using your appliance for the first time, clean all the accessories (C) in warm soapy water, except for the motor unit (A, B). aTTENTION: DO NOT IMMERSE THE MOTOR UNIT/CONTROL PANEL (A , B) OR PUT IT UNDER WATER OR ANY OTHER LIQUID. CAUTION: The blades are extremely sharp; handle them with caution when using or cleaning the appliance. [. . . ] Choose the optional program function by means of the buttons “ice crush”, “smoothie” or “auto-clean”. Each function has a programed processing time (see more under the different functions), but blending can be stopped manually by pressing the on/off button in the middle of the function selector. The blender also has a variable speed selector that is activated by turning the function button to setting min-max. Disconnect the appliance and let it cool down for about 30 minutes, then resume use. EN Functions of the blender: Ice crush: Put max 200 g of ice cubes in the jug. 1 minute unless it is switched off manually by means of the on/off button or by pressing the ice crush button. 1 minute unless it is switched off manually by means of the on/ off button or by pressing the smoothie button. The blender works at various speeds alternating for 45 seconds, unless it is switched off manually by means of the on/off button or by pressing the Autoclean button again. Note that ice crush, smoothie and the auto clean functions cannot be activated, when you use the variable speed function. Turn the function selector to the required speed and start the blending by means of the on/off button. Switch off the blender by pressing the on/off button in the middle of the function button and turn the function button back to 0. € We recommend that you experiment to find the speed that is best for the ingredients to be mixed. Always check on the mixing and switch off the appliance, when the desired result has been obtained. mixing of hot liquid • The glass jug can withstand hot ingredients and hot liquids/ soups. Be careful if hot liquid is poured into the blender as it can be ejected out of the appliance due to a sudden build up of steam. The temperature of the liquid in the blender should not exceed 80°C. Operate the blender at MIN setting and pour the liquid (hot stock, cream or similar) slowly through the opening in the lid. If the blender is switched off when the jug contains hot liquid and is restarted, pressure from the bottom may cause the lid to eject due to the high rotation of the motor. € If the blender has been switched off during the above process and needs to be restarted, place a towel, oven glove or similar over the jug and hold it down with your hand. € Hot liquids alone must not be processed in the blender, since the pressure in the jug will be too high. [. . . ] Clean the locking ring (C1), blade holder (C2) and seal (C3) under running water or in the dishwasher on the upper rack using the “ECO” program (except the the seal - C3 which is not dishwasher safe). € The glass jug (C4) can be cleaned in the dishwasher on the upper rack - use the ‘ECO’ or ‘LOW SALT’ program. Check that the jug or accessories are correctly positioned and locked onto the motor unit as shown in the figure in the manual. The jug or accessory is not correctly positioned or locked on the motor unit. [. . . ]