User manual MOULINEX JU320172

[. . . ] €¢ For your safety, this appliance is compliant with applicable standards and regulations: - Low Voltage Directive - Electromagnetic compatibility directive - Regulations governing materials in contact with food. €¢ Check that the supply voltage shown on the rating plate of the appliance matches that of your electrical system. €¢ Do not place or use this appliance on a hotplate or close to an open flame (gas cooker). [. . . ] DESCRIPTION A B C D E F Pusher Feed tube Cover Sieve Juice collector Pouring spout G H I J K L Non-drip spout Pulp collector Safety clamps Control button Drive shaft Motor unit 8 9 SAFETY SYSTEM To start the juicer, the cover (C) must be fitted correctly (Fig. At the end of a cycle, turn the control button to "0" and wait until the sieve (D) stops completely before removing the cover (C). BEFORE FIRST USE We recommend that you wash the removable parts (A, B, C, D, E, F, G, H) before the first use (see section "Cleaning and care"). €¢ Unpack the appliance and then place it on a solid, stable worktop, remove the cover (C) and take out the protective card on the sieve (D). €¢ When you have finished, stop the appliance by turning the control button (J) to 0 and wait until the sieve (D) stops completely. €¢ When the pulp collector (H) is full, or the juice flow slows down, empty the pulp collector (H) and clean the sieve (D) and the cover (C). €¢ After making your juice, turn the non-drip spout (G) by 180° before removing the glass to stop the juice flow (see Fig. Ingredients Approximate weight (kg) Quantity of juice obtained in ml (*) – 1 glass = 200 ml (approximately) 650 600 600 600 300 450 600 600 USING THE APPLIANCE Apples • Place the juice collector (E) on the body of the appliance (see Fig. Ensure that the sieve is properly clipped onto the drive shaft (K) (see Fig. €¢ Fit the cover (C) on the appliance in order to have the pulp evacuation exit to the rear (see fig. €¢ Fit the pulp collector (H) on the rear of the appliance (see Fig. €¢ Slide the pusher (A) into the feed tube (B) aligning the groove on the pusher with the small ridge in the feed tube. • Your appliance is equipped with a non-drip spout (G). €¢ Place a glass under the non-drip spout in front of the appliance (see Fig. [. . . ] CLEANING AND CARE • All removable parts may be cleaned in the dishwasher (A, B, C, D, E, F, G, H). The appliance is easier to clean if rinsed with water immediately after use and then cleaned fully later. The appliance is giving off a smell or is very hot to the touch or is smoking or making an abnormal noise. [. . . ]