User manual MOULINEX IM 3140

[. . . ] Visit divx. com for more information and software tools to convert your files into DivX videos. ABOUT DIVX VIDEO-ON-DEMAND: This DivX Certified® device must be registered in order to play purchased DivX Video-on-Demand (VOD) movies. To obtain your registration code, locate the DivX VOD section in your device setup menu. Go to vod. divx. com for more information on how to complete your registration. [. . . ] If yy you do not use an optional external speaker, connect the PC to the TV with the optional audio cable. yy (Not Provided) (Not Provided) or PC (Depending on the model) 30 MAKING CONNECTIONS RGB connection ENGLISH Transmits the analog video signal from your PC to the TV. Connect the PC and the TV with the D-sub 15 pin cable as shown the following illustrations. To transmit an audio signal, connect an optional audio cable. NOTE If you do not use an optional external speaker, connect the PC to the TV with the optional audio cable. (Not Provided) (Not Provided) PC or (Depending on the model) REMOTE CONTROL 31 REMOTE CONTROL ENGLISH The descriptions in this manual are based on the buttons of the remote control. To replace batteries, open the battery cover, replace batteries (1. 5 V AAA) matching and ends to the label inside the compartment, and close the battery cover. To remove the batteries, perform the installation actions in reverse. CAUTION Do not mix old and new batteries, as this may damage the remote control. Make sure to point the remote control to the remote control sensor on the TV. Image shown may differ from your TV. (POWER) Turns the TV on or off. TV/RAD Selects Radio, TV and DTV programme. MUTE Mutes all sounds. SUBTITLE Recalls your preferred subtitle in digital mode. LIST Displays the programme table. Adjusts the volume level. + - PAGE 32 REMOTE CONTROL ENGLISH SETTINGS Accesses the main menu. INFO ⓘ Views the information of the currently program and the screen. EXIT Clears all on-screen displays and returns to TV viewing from any menu. Do yy not use any chemicals, such as waxes, benzene, alcohol, thinners, insecticides, air fresheners, lubricants, as these may damage the screen’s finish and cause discolorations. Cabinet and stand To remove dust, wipe the cabinet with a dry and soft cloth. To remove major dirt, wipe the cabinet with a soft cloth dampened in a clean water or water containing a small amount of mild detergent. CAUTION Do yy not spray liquid onto the surface. If water enters the TV, it may result in fire, electric shock, or malfunction. Do yy not use any chemicals as this may deteriorate the surface. Power cord Remove the accumulated dust or dirt on the power cord regularly. 36 MAINTENANCE Preventing “Image burn” or “Burn-in” on your TV screen ENGLISH If yy a fixed image displays on the TV screen for a long period of time, it will be imprinted and become a permanent disfigurement on the screen. This is “image burn” or “burn-in” and not covered by the warranty. If yy the aspect ratio of the TV is set to 4:3 for a long period of time, image burn may occur on the letterboxed area of the screen. Avoid displaying a fixed image on the TV screen for a long period of time (2 or more hours for LCD) yy to prevent image burn. TROUBLESHOOTING 37 TROUBLESHOOTING ENGLISH General Problem Cannot control the TV with the remote control. Resolution yy Check the remote control sensor on the product and try again. yy Check if there is any obstacle between the product and the remote control. yy Check if the batteries are still working and properly installed ( to , to ). yy Check if there is a problem in the wall outlet by connecting other products. [. . . ] Ack [a][ ][Set ID][ ][OK][Data 00][Data 01] [Data 02][Data 03][Data 04][Data 05] [x][a][ ][Set ID][ ][NG][Data 00][x] ENGLISH 18.  hannel(Programme) Add/Del(Skip) (Command: C m b) ► To skip current channel(programme) for next time. Transmission [m][b][ ][Set ID][ ][Data][Cr] Data 00 : Del(ATSC, ISDB)/Skip(DVB) 01 : Add Ack [b][ ][Set ID][ ][OK/NG][Data][x] * Set the saved channel status to del(ATSC, ISDB)/ skip(DVB) or add. 19. Transmission [m][c][ ][Set ID][ ][Data][Cr] Data Key code - See p. 42. [. . . ]