User manual MOULINEX GM 5010

[. . . ] €¢ Never leave the appliance unattended : - when it is connected to the mains, - until it has cooled down (around 1 hour). €¢ The soleplate and generator iron-rest can become very hot and cause burns: never touch these parts. Handle your iron carefully, particularly when using the vertical steam function. €¢ Never unscrew the boiler cap while the appliance is on. [. . . ] Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Boiler (inside the base-unit) Steam cord storage space Steam cord Electric cord tidy Power cord Illuminated on/off switch PREPARATION What water to use ? • Your iron has been designed to operate using untreated tap water. €¢ Types of water not to use: Heat concentrates the elements contained in water during evaporation. The types of water listed below may contain organic waster, mineral or chemical elements that can cause spitting, brown staining or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries, air conditioners, rain water, boiled, filtered or bottled water. These types of water should NOT be used in your MOULINEX steam generator. If your water is very hard (check with your local water authority) it is possible to mix tap water with store-bought distilled or demineralised water in the following proportions : 50% untreated tap water, 50% distilled or demineralised water. Ironing Boards Due to the powerful steam output, a mesh type ironing board must be used to allow any excess steam to escape and to avoid steam venting sideways. Filling the boiler Place your steam generator on a flat, stable, heat-resistant surface. €¢ Replace the boiler cap, screwing on firmly, but not over tight. €¢ • • • Starting the generator • Unwind the electric cord completely and take the steam cord out of its housing. €¢ Replace the boiler cap, screwing on tightly, Plug your generator back into the mains, and switch it on. Storing the generator • • • • • Turn off at the main switch and unplug. Leave the steam generator to cool down before putting it away if it is stored in a cupboard or confined space. €¢ You can store your steam generator in complete safety. Place it on the iron-rest on the base unit : it has non-slip pads and has been designed to withstand high temperatures. MAINTENANCE AND CLEANING Before cleaning, ensure that your steam generator is unplugged and that the soleplate and the iron rest have cooled down. Do not use detergent or descaling products for cleaning the soleplate or the base unit. Cleaning the soleplate • Regularly clean the soleplate with a non-metallic sponge. Cleaning the unit • Clean the plastic parts of the appliance occasionally with a soft dampened cloth. Rinsing the boiler (once a month) • Be careful : To extend the life of your boiler and to avoid the build-up of scale, it is essential that you rinse out the boiler at least after every 10 uses (approximately once a month). €¢ Check that the generator is cold and unplugged for more than 2 hours. [. . . ] SOLUTIONS Check that your appliance is correctly plugged in Press on the steam control button away from your ironing board until the iron produces steam. Wait for the thermostat light to go out before activating the steam button. A mesh type ironing board must be used to allow any excess steam to escape. Never add this type of product in the water tank or in the boiler (see § “for what water may be used”). [. . . ]