User manual MITSUBISHI TG-2000A FLOOR CHANGE OPERATION METHOD

[. . . ] FLOOR CHANGE OPERATION METHOD OF TG-2000A (INTEGRATED CENTRALIZED CONTROL SOFTWARE) Let us move to the [System set screen]. Select the floor name when the floor No. [. . . ] By using the applicable operation of the Paint, the floor plan is modified. Air-conditioning group Grid selection General equipment group To change the icon Click the [Delete]. Returns to the group list deleted from the floor. For the change of a floor, the following steps are required to observe. · Step2 : Set-up of the number of floors, and floor names · Step3 : Creation of a plane view · Step5 : Set-up of icon arrange and name · Step6 : Set-up of block Advance by clicking the [OK] button until obtaining the Step screen you desire to change. Column of group list To change the group name When the group name is modified, select the [Name change], and to move the configur-ation, select the [Move]. Move to the destination changed, and move the icon by tapping. To change the configuration and name of icon Go to the [Step 5 : Set-up of icon arrange and name]. Select the floor name, and click the group icon you desire to change. To change the block Caution and notice · The password can be changed. In the case when your password has been changed, the above may differ. · When the password has not been changed, enter in capital letters. The key operation with Shift + Caps Lock key creates capital letters (with the Caps Lock lamp being lighted). [. . . ] To set the block Click the [Block set] button. Select the floor name, and select the group icon of which block registration is desired to change. To set the block name Click the [Block name change] button. Select the existing block of which name is desired to change, and enter a new name. (for TG-2000A Ver. 4. 10) WT04080X02 [. . . ]