User manual MINOURA PAIR STAND

[. . . ] Bicycle display stand "PAIR STAND" instruction manual Please read this instuctions carefully before use. Thank you for purchasing Minoura PAIR STAND bike display stand. This stand can hold up to two bikes horizontally in a space as same as for only one bike. IMPORTANT NOTES ! This stand is designed for standard two wheel bicycles. [. . . ] Be sure to fit the legs to the shape of the horrow of the bottom plate. Lower Pillar Rear Leg Bottom Plate Reinforcement Arm Front Leg (Fig. B) (Fig. C) 4 Place the Connecting Plates at the top of the Lower Pillar. Connect the Upper Pillar to the Lower Pillar then tighten the M6x14 bolts firmly. Place the Angle Adjust Plate onto the Lower Support, then put the Alloy Stay on it. E) Screw the supplied M6x15 bolt in the lower hole, but you don't need to tighten it so firmly at this time. The cradle is adjustable in degrees. If you want to move the cradle, loosend the lower bolt on the angle adjust plate, change the angle until the displayed bike will be horizontally as much as possible then (Fig. I) To put a bike on PAIR STAND, lift the bike and gently place the top tube into the frame hooks. If the bike does not have a standard frame design, it should be supported by the top tube and rear seatstay configuration. E) 6 The distance between the plastic frame hooks can be adjusted to fit different sized bikes. F) ! The stainless band must ONLY be used on the upper side of the cradle. G) The inside nut of the stainless band clamp is not square, it is rectanle. [. . . ] Put the plastic bracket onto the band, attach the hook or support arm, then tighten the bolt. (for North American residents only) 1996 East Avenue, Hayward, CA 94541-5454 U. S. A. Fax: 1-510-538-5899 / Email: MinouraUSA@ATTglobal. net MADE IN JAPAN Copyright 2002 Minoura Co. , Ltd. [. . . ]