User manual MINOURA NW-300

[. . . ] FCG-310 & NW-300 instructions manual This is the instructions for the tools contained in the True-Pro Combo kit. FCG-310 is the tool to check if the wheel is exactly symmetrical for better ride. [. . . ] Extend until the grooves meet and lock into place by pushing them each other. Turn the Gauge Plate counter-clockwise to locate the hole at the down end side. Tighten the Knob Bolt, but you don't need to tighten it so firmly at this moment. If the Gauge Plate doesn't fit to the flat groove on the Ratch correctly, you won't be able to measure properly. While keeping both Rim Guides touching the rim, loosen the Knob Bolt to adjust the Gauge Plate position, then tighten the Knob Bolt when the Gauge Plate end touches the hub. 5. A) At this moment, make sure the following points; · Both Rim Guides touch the rim. · The wheel axle is running through the hole on the Gauge Plate, and the Gauge Plate touches the hub. 6. Flip over the wheel and attach the FCG-310 onto the opposite side of the wheel. At this time, if all three points (both Rim Guides and the tip of the Gauge Plate) touch each appropriate position at once on both side of the wheel (see Fig. But if either one of the Rim Guides or the Gauge Plate doesn't touch the appropriate position (see Fig. C), your wheel needs to be adjusted further. Properly Adjusted (Fig. C) If the Rim Guide doesn't touch the rim, the wheel has been moved toward opposite side. If the Gauge Plate doesn't touch the hub even though both Rim Guides touch the rim, your wheel has been moved backward. [. . . ] You must stop tightening after turning 1/2 rotation at once at widest. Once the nipple is damaged, you won't be able to continue any work on wheel. [. . . ]