User manual LINE 6 BACKTRACK ADVANCED GUIDE

[. . . ] BackTrack Series ® Advanced Guide Rev A Windows Requires . NET Framework 2. 0 or Higher The Windows version of the BackTrack Setup Utility requires the Microsoft . NET Framework version 2. 0 or higher. This is included in the BackTrack Setup Utility Installer, available for download from www. line6. com/software, and on BackTrack, accessible from computer when mounted via USB. [. . . ] The table below is correct: BackTrack + Mic 24 hours 12 hours 8 hours 6 hours 5 hours 4 hours 4 hours BackTrack 12 hours 6 hours 4 hours 3 hours 2. 5 hours 2 hours 2 hours Sample Rate 11 kHz 22 kHz 32 kHz 44. 1 kHz 48 kHz 44. 1 kHz 48 kHz Bit Depth 16 bit 16 bit 16 bit 16 bit 16 bit 24 bit 24 bit CD audio standard Notes * * * These settings are not recommended for mic full range audio, but may be sufficient for direct guitar Clipping for Mic When clipping (overly loud audio) is detected while the mic is being used for auto capture, the indicator will light red. White Light During Startup/Shutdown While powering up, the status light will be white, as the BackTrack prepares to provide normal operations. Flashing White Light When Busy The status light will flash white when BackTrack is busy, and unable to perform other functions. Purple Light The printed Pilot's Handbook says that the light will be continually purple when less than 5 minutes of memory remains. This is incorrect: the light always flashes purple when memory is low. Quit Features for BackTrack Setup Utility The printed manual shows an image of the BackTrack Setup Utility that shows buttons for Quit Without Saving and Save and Quit. When quitting, you will be asked whether you want to save, if there are unsaved changes. Version Display for BackTrack Setup Utility The title bar of the BackTrack Setup Utility includes the version number of the utility software. Please note this version, when contacting Customer Support with issues related to the software. The latest version of the BackTrack Setup Utility is available at www. line6. com/software . Audio Files Created by BackTrack Files created by BackTrack will be named beginning with "BT", followed by a 5 digit number, then "G" (if the files was recorded from 1/4-inch guitar input) or M (if the audio was recorded from mic), then ". WAV". [. . . ] Download the firmware file, then click the Update Firmware button and locate that file using the Open File window that is provided. Follow the onscreen instructions to complete the update. Guitar and Mic Auto Capture Presets The following presets are available from the BackTrack Setup Utility: GUITAR PRESETS Electric Guitar/Bass Auto Capture ­ Soft Min Event ­ 2 sec Min Silence ­ 1 sec Active Bass/Noisy Guitar Auto Capture ­ Medium Min Event - 2 sec Min Silence ­ 1 sec Guitar through POD or FX Auto Capture ­ Loud Min Event - 2 sec Min Silence ­ 2 sec MIC PRESETS Soft/Acoustic Auto Capture ­ Medium Min Event ­ 1 sec Min Silence ­ 1. 5 sec Mic Gain ­ 5 AGC - Off Med/Electric Auto Capture ­ Medium Min Event ­ 1. 5 sec Min Silence ­ 2 sec Mic Gain ­ 5 AGC - Off Loud/Full Band Auto Capture ­ Loud Min Event - 2 sec Min Silence ­ 2 sec Mic Gain ­ 2 AGC - Off Page 10 of the printed Pilot's Handbook lists Low, Medium and High as available choices for Guitar Auto Capture. [. . . ]