User manual LG DT924

[. . . ] ENGLISH OWNER’S MANUAL Portable DVD Player Please read this manual carefully before operating your set and retain it for future reference. DT924 DT924-P. AFRALLK_1515-ENG. indd 1 2012-03-02 4:52:56 1. Getting Started 2 Getting Started Use of controls, adjustments or the performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION concerning the Power Cord Most appliances recommend they be placed upon a dedicated circuit; That is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner’s manual to be certain. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous. [. . . ] STOP (Z): Stops playback. Battery Installation Remove the battery cover on the rear of the Remote Control, and insert the battery with the + facing in the same direction as the + on the battery compartment. yy Replace Remote Control’s battery with 3 V micro lithium cells such as CR. The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, incinerate, or heat above 100 °C (212 °F). Do not disassemble or dispose of in fire. Warning >> DT924-P. AFRALLK_1515-ENG. indd 9 2012-03-02 4:53:08 10 Getting Started To revolve the LCD panel to its original position, open the LCD panel to a vertical position. yy When finished using the unit, return the LCD panel to its original position. Supplied Accessories 1 Getting Started RCA Video/Audio Adaptor (1) Remote control (1) yy Do not leave the LCD panel in the face-up position, or sudden shocks may damage it. Rechargeable battery yy The internal rechargeable battery provides you with the freedom to pass it around and play the files without the power cord. yy The internal rechargeable battery will start charging only when the unit is turned off and the AC adaptor is connected to a power outlet. yy The charging will take approximately 2 hours and 30 minutes. Automotive Adaptor (1) Battery for Remote Control (Lithium Battery) (1) Headrest Mounting Bracket (1) AC Adaptor (MPA-20P) (1) • The actual AC Adaptor may differ from the drawing. yy Operating time on battery: approximately 3 hours and 30 minutes. The operating time on battery may vary depending on the battery status, operational status and environment conditions, and the maximum playing time is possible up to 5 hours. yy When the remaining time of the battery power is under a few minutes, “ Check Battery” will blink on the screen. Revolving the LCD panel You can revolve the LCD panel of the unit clockwise a maximum of 180 degrees for use. You can also operate the unit after revolving the LCD panel 180 degrees and folding it back down. To revolve the LCD panel, place the unit on a stable and even surface such as on a table. If you need, fold the LCD panel after revolving it. DT924-P. AFRALLK_1515-ENG. indd 10 2012-03-02 4:53:12 Connecting 11 Connecting the AC Adaptor Connect the unit to the power supply with the supplied AC Adaptor. Connecting the Automotive Adaptor Connect the unit to the Cigarette lighter socket with the supplied Automotive Adaptor. Plug into a power source. 2 Connecting Plug into the car’s cigarette lighter socket. yy Contact an electrical parts distributor for assistance in selecting a suitable AC plug adaptor or AC cord set. yy This AC adaptor is manufactured by NANJING WANLIDA TECHNOLOGY CO. , LTD. Do not use a power supply from another device or another manufacturer. Using any other power cable or power supply may cause damage to the device and void your warranty. • Contact an electrical parts distributor for assistance in selecting a suitable Automotive Adaptor. • This Automotive Adaptor is manufactured by NANJING WANLIDA TECHNOLOGY CO. , LTD. Note , , Connecting Audio and Video cable Connect the AV OUT on the unit to AV cable connected from TV with the supplied AV Adaptor. Audio/Video Cable (not supplied) (White) (Red) (Yellow) DT924-P. AFRALLK_1515-ENG. indd 11 2012-03-02 4:53:14 3 System Setting 12 System Setting Settings When the unit is turned-on at the first time, you have to select the desired language. (optional) [DISPLAY] Menu TV Aspect Select which screen aspect to use based on the shape of your TV screen. [16:9]: Select when a 16:9 wide TV is connected. Adjust the Setup Settings You can change the settings of the unit in the [Setup] menu. 2. Use w/s to select the first setup option, and press d to move to the second level. 3 System Setting 3. Use w/s to select a second setup option, and press d to move to the third level. 4. Use w/s to select a desired setting, and press ENTER (b) to confirm your selection. Display Mode If you selected 4:3, you’ll need to define how you would like widescreen programs and films to be displayed on your TV screen. [Letterbox]: This displays a widescreen picture with black bands at the top and bottom of the screen. [. . . ] ZOOM: 100% : 200% : 300% : 400% : 100% w/s/a/d: Move through the zoomed photo. Listen to music You can listen to music during during slide slide show, if the disc contain show music and photo files together. Use w/s/a/d to highlight (~) icon then press ENTER (b) to start slide show. 4 Operating DT924-P. AFRALLK_1515-ENG. indd 17 2012-03-02 4:53:15 5 Troubleshooting 18 Troubleshooting Troubleshooting Symptom No power Cause The power cord is disconnected. The battery is discharged. Solution Plug the power cord into the wall outlet securely. [. . . ]