User manual LA CROSSE TECHNOLOGY WS-9014TWC

[. . . ] An outdoor wall or window will have 20 to 30 feet of resistance and an interior wall will have 10 to 20 feet 5 of resistance. NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor temperature station after the 10 minutes have passed please follow the steps below. Note: A "12h" or "24h" will appear on the top line. [. . . ] Press and release the "MIN/MAX" button to toggle to the maximum temperatures. The time of occurrence of the value for outdoor temperature will also flash. B. To reset both the minimum and maximum temperatures--press and hold the "RESET/+" button for 4 seconds. C. The WS-9014U is able to receive signals from 3 different remote temperature sensors. Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-9014U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6 will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP will monitor the temperature via a probe for use in pools, spas, etc. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensor units, and in numeric sequence. Transmission problems will arise if this is not done correctly and if 14 the total time for set-up exceeds 6 minutes. It is necessary to remove the batteries from all units currently in operation. Place all remote temperature sensor units in a numeric sequential order. In sequential order, install batteries (follow the same battery installation procedures seen in section "I" of the Detailed Set-Up Guide). Follow the Detailed Set-Up Guide for programming and operating instructions. D. VIEWING AND OPERATING WITH MULTIPLE REMOTE TEMPERATURE SENSOR UNITS 1. To view the temperature of a different remote temperature sensor unit, press and release the "CH" button. A shift 15 from one "boxed" number to the next should be observed in the OUTDOOR LCD. To view the Minimum/Maximum temperature: first select from which remote temperature sensor to read data (indicated by the "boxed" number). Pressing and releasing the "MIN/MAX" button will toggle through the minimum and maximum indoor temperature, and the minimum and maximum outdoor temperature. [. . . ] Do not use solvents or scouring agents; they may mark the displays and casings. Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. Contact La Crosse Technology for repairs. · · · 20 SPECIFICATIONS Transmitting 433MHz Frequency Measuring Temperatures Indoor 32°F to 156. 2°F with Temperature 0. 2°F resolution. Station: Indoor (0°C to 69. 0°C with 0. 1°C resolution) Indoor -21. 8 °F to 156. 2°F with Temperature 0. 2°F resolution. [. . . ]