User manual LA CROSSE TECHNOLOGY WS-8001U

[. . . ] 3) If there is no WWVB reception, manually set the time and date (instructions in the Program Mode). 5) Mount the WS-8001U in a suitable location, where WWVB signals can be received. DETAILED SET-UP GUIDE I) BATTERY INSTALLATION Note: To avoid start-up problems make sure that the batteries do not spring free. A) MOON PHASE CLOCK Battery Compartment Battery Cover 3 1) Remove the battery cover, located on the backside of the unit and directly below the function buttons. [. . . ] There are 3 languages to select from: US F E English French Spanish 3) Press the "SET" button to confirm the language setting, and to advance to manually set the time. V) TIME SETTING Note: When the WWVB signal is found, that time will over-ride the manually set time. 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash), press the "SET" button 3 more times, until the hour "12" flashes in the time LCD. Note: when setting the hour, "PM" will appear to the left of the hour display, if it is AM nothing will be displayed. 3) Press the "SET" button to confirm the hour setting, and to shift to select the minutes. 5) Press the "SET" button to confirm the time setting, and to advance to manually set the calendar. VI) CALENDAR SETTING Note: When the WWVB signal is found, that date will over-ride the manually set date. 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash), press the "SET" button 5 more times, until the default year "00" flashes in the date LCD. 3) Press the "SET" button to confirm the year, and to set the month. 5) Press the "SET" button to confirm the month, and to set the date. 6 6) The default date "1" will flash. 7) Press the "SET" button to confirm the date, and to set the weekday. 8) The default weekday "MON" (depends on selected language) will flash. 9) Press the "SET" button to confirm the calendar settings, and to advance to select either 12 or 24-hour time display. VII) 12/24-HOUR SETTING 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash), press the "SET" button 9 more times, until the "12" hour time display flashes in the time LCD. 2) Press the "+" button to toggle between 12 and 24 hour time. 3) Press the "SET" button to confirm the 12/24-hour time display, and to advance to select either °F or °C. VIII) SELECTING °F OR °C 1) Hold down the "SET" button for 2 seconds (the selected time zone will flash), press the "SET" button 10 more times, until the default "°F" flashes in the time LCD. 2) Press the "+" button to toggle between °F and °C. 3) Press the "SET" button to confirm the °F or °C selection, and exit the Program Mode. FEATURES & OPERATIONS I) CHANGING DISPLAY MODE (DAY, SECONDS, AND TEMPERATURE) There are three possible display modes to view the day, seconds, and temperature. The month&date/weekday/moon phase/indoor temperature is the default. The display should now show the month&date/weekday/moon phase/seconds. [. . . ] 2) Install three mounting screws (not included) into a wall within transmission range--leaving approximately 3/16 of an inch (5mm) extended from the wall. 3) Place the Moon Phase Clock onto the screws, using the hanging holes on the backside. MAINTENANCE & CARE · · · · · Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units. Do not use solvents or scouring agents--they may mark and damage the displays and casings. [. . . ]