User manual LA CROSSE TECHNOLOGY WS-7049U-MAH

[. . . ] NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor weather station after the 10 minutes have passed please follow the steps on pages 8 and 9. Note: The remote temperature sensor transmits a signal every 3 minutes; after the batteries have been installed, the indoor weather station will search for the signal for a duration of 5 minutes. If there is no temperature reading in the OUTDOOR LCD after 5 minutes, make sure the units are within range of each other or repeat the battery installation procedure. 4 DETAILED SET-UP GUIDE Battery Installation A. [. . . ] The maximum recorded indoor and outdoor temperatures will be displayed in their respective areas. The maximum recorded indoor and outdoor temperatures will be displayed in their respective areas. The current indoor and outdoor temperatures will be displayed in their respective areas. B. Resetting the Minimum and Maximum Temperature Records 9 Press and hold the "MIN/MAX/RESET" button for 5 seconds to reset the minimum and maximum recorded temperatures. Adding Remote Sensors (optional) The WS-7049U is able to receive signals from 3 different remote temperature sensors. The remote temperature sensor model(s) that you choose will come with their own set of instructions. Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-7049U. These extra remote temperature sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP will monitor the temperature via a probe for measuring soil or water temperatures. . Note: When setting up multiple units it is important to remove the batteries from all existing units in operation. Then insert batteries into all the remote temperature sensor units in numeric sequence. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. It is necessary to remove the batteries from all units currently in operation. Place all remote temperature sensor units in a numeric sequential order. Follow the Detailed Set-Up Guide for programming and operating instructions. 10 B. Viewing and Operating Multiple Remote Sensors To view the temperature of a different remote sensor unit, press and release the "CH" button. An arrow over one of the numbers at the bottom of the LCD will be seen. Press and release the "CH" button to select which remote temperature sensor to read data from (indicated by the arrow). Press and release the "MIN/MAX/RESET" button (while "MIN" is still displayed, otherwise press the button twice). Select which remote sensor you wish to reset by pressing the "CH" button. The records for the selected remote sensor unit will be reset. Note: The minimum and maximum indoor temperature values will be reset when any of the remote temperature values are reset. 11 MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on a North-facing wall. [. . . ] Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology 2809 Losey Blvd. La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 e-mail: support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. [. . . ]