User manual LA CROSSE TECHNOLOGY WS-7047TWC

[. . . ] An outdoor wall or window will have 20 to 30 feet of resistance and an interior wall will have 10 to 20 feet of resistance. NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor weather station after the 10 minutes have passed please follow the steps on pages 4 to 6. DETAILED SET-UP GUIDE FOR THE WIRELESS WEATHER STATION 3 I) Battery Installation Note: Batteries will fit tightly. To avoid start-up problems make sure that the batteries do not spring free. [. . . ] Place the 3 tabs (on the rainfall collector) into the tab slots (on the base) and turn counter-clockwise. II) The Remote Temperature Sensor The remote temperature sensor can be mounted in two ways: 5 · · with the use of screws using the adhesive tape A. Through the three screw holes of the bracket, mark the mounting surface with a pencil. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. Adhere the tape to the designated area on the back of the mounting bracket. Position the remote temperature sensor in the desired location, ensuring that the indoor temperature station can receive the signal. III) The Indoor Weather Station The indoor weather station can be mounted in two ways: · with the table stand · on the wall with the use of a wall hanging screw (not included). Using the Table Stand The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the indoor weather station in an appropriate location. Fix a screw (not included) into the desired wall leaving approximately 3/16 of an inch (5mm) extended from the wall. Place the indoor temperature station onto the screw using the hanging hole on the backside. OPERATION OF THE WIRELESS WEATHER STATION 6 A) Viewing the Temperature (Remote and Indoor) 1. The indoor temperature will display in the Temperature portion of the LCD. To View the remote temperature press and release the "RESET" button. Press and release the "RESET" button to return to the indoor temperature. B) Viewing the Rainfall 1. The rainfall total will be displayed in the Rainfall portion of the LCD. To reset the rainfall total to 0. 00 press and hold the "RESET" button for 3 seconds. TROUBLESHOOTING NOTE: For problems not solved please contact RadioShack. Problem: The LCD is faint Solution: Replace batteries 7 Problem: No outdoor temperature is displayed. Remove all batteries, reinsert into remote rain sensor first, then into the remote temperature sensor and then into the indoor temperature station. Place remote temperature sensor and indoor weather station in a position so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature sensor is manufactured to be accurate to within 1 degree plus or minus and under normal conditions; so two sensors could be as much as 2 degrees different. However, the difference can be exaggerated further because the sensors are designed for different working environments. [. . . ] (59 x 22 x 65 mm) Remote rain sensor 5. 19in diameter x 7. 20in high (132mm diameter x 183mm high) Battery life Approximately 1 year WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this indoor weather station. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the indoor weather station in for repairs, contact La Crosse Technology. The indoor weather station will be repaired or replaced with the same or similar model. 9 This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the indoor weather stations inability to receive a signal due to any source of interference. [. . . ]