User manual LA CROSSE TECHNOLOGY WS-7044UG INSTRUCTION MANUAL

[. . . ] This means that if you can install the new batteries within this 20-second time period you do not need to program the Station again. 6 II. THE TIME DISPLAY The time is displayed vertically (with the hour displayed above the minutes) rather than in the conventional horizontal format. The hour and minute displays are separated by a flashing dot, which indicates the seconds. SETTING THE TIME Note: The "SET" and the "+" buttons are located on the backside of the Weather Temperature Station, and are labeled accordingly. [. . . ] An arrow pointing up indicates that the air pressure is increasing and the weather is expected to improve or remain good, an arrow pointing down indicates that the air pressure is decreasing and the weather is expected to become worse or remain poor. OUTDOOR TEMPERATURE--WITH MINIMUM & MAXIMUM FEATURE The Weather Temperature Station receives the outdoor temperature from the Remote Temperature Transmitter, and the temperature appears in the OUTDOOR LCD. The Remote Temperature Transmitter makes a temperature update every 1 minute, and transmits a new temperature to the Weather Temperature Station 3 times every 10 minutes. The Weather Temperature Station also keeps a record of the Minimum and Maximum temperatures it has recorded. 13 A. An arrow will appear and point to the "MIN" that is printed in the right-hand margin. Press the MIN/MAX a second time and the arrow will shift to point to the "MAX" that is printed in the right-hand margin. Press the MIN/MAX a third time, and the OUTDOOR LCD returns to display the current outdoor temperature. 14 B. This will reset all records to the current outdoor temperature. MOUNTING Note: Extreme and sudden changes in temperature will decrease the accuracy of the Weather Temperature Station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Temperature Transmitter. We recommend that you mount the Remote Temperature Transmitter on a Northfacing wall. The sending range is 80ft (25m)-- obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in 15 their desired location, and wait approximately 10 minutes before permanently mounting to ensure that there is proper reception. The Weather Temperature Station should display a temperature in the OUTDOOR LCD within 3 minutes of setting-up. THE REMOTE TEMPERATURE TRANSMITTER The Remote Temperature Transmitter can be mounted in two ways: · with the use of screws, or · using the adhesive tape. Through the three screw holes of the bracket, mark the mounting surface with a pencil. Snap the Remote Temperature Transmitter onto the mounted bracket. B. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. Adhere the tape to the designated area on the back of the mounting bracket. Position the Remote Temperature Transmitter in the desired location, ensuring that the Weather Temperature Station can 17 2. 3. receive the signal. [. . . ] (59 x 21 x 65mm) 22 WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this weather station. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the Weather Station in for repairs, contact La Crosse Technology. The Weather Station will be repaired or replaced with the same or similar model. [. . . ]